Fisher-Price CJJ03, Y8618 Instruction Sheet
GAUNTLET
ATTACHING TARGETS
6
REMOVING DARTS
7
WARNING: Do not aim at eyes or face. Only use
projectiles supplied with this toy.
Do not fire at point blank range.
Always wear appropriate eye-wear,
sold separately.
INSTRUCTIONS
Please keep these instructions for future reference as they contain important information.
Peel backing off target before sticking it to surface.
Do not stick target to walls or furniture as
✖
it may cause damage to the surface.
CLEANING DARTS
8
IMPORTANT:
Always remove darts from target after play.
Keep one hand pressed on target, hold dart
by the tip and gently peel dart off.
REPLACING TARGETS
9
& SHIELDS
Y8620/BBY17
Replace time-worn targets and shields with
Y8620/BBY17 SMART STICK REFILLS.
CONTENTS
1
SHIELDS
2
A. Activate shields.
CAUTION: Do not aim at eyes or face.
TO AVOID INJURY: Use only darts
designed for this product.
Do not modify darts or dart blaster.
x 30
B. To close shields.
Dust, dirt, and other debris can cause darts to lose
their adhesiveness.
To clean darts, rinse darts’ tips with tap water or use
tape to remove excess debris.
NOTE: Dry darts before using again.
©2014 Mattel. All Rights Reserved. Mattel, Inc., 636 Girard Avenue, East Aurora, NY 14052, U.S.A. Consumer Relations
1-800-524-8697. Mattel U.K. Ltd., Vanwall Business Park, Maidenhead SL6 4UB. Helpline 01628 500303. Mattel Australia Pty.,
Ltd., Richmond, Victoria. 3121.Consumer Advisory Service - 1300 135 312. Mattel East Asia Ltd., Room 503-09, North Tower, World
Finance Centre, Harbour City, Tsimshatsui, HK, China. Diimport & Diedarkan Oleh: Mattel SEA Ptd Ltd.(993532-P) Lot 13.5, 13th
Floor, Menara Lien Hoe, Persiaran Tropicana Golf Country Resort, 47410 PJ. Malaysia. Tel:03-78803817, Fax:03-78803867.
4
Each sold separately, subject to availability.
Y8618-0920
Detach shields as desired.
a
Click!
b
1
TO FIRE
3
A. Fully load clip with darts.
Pump sliding handle all the way forward and all the
C.
way back up to 18 times for maximum fire power.
18x
RESET
4
A. Remove empty clip from blaster. B. Press RESET button and trigger.
Hold to release all air from blaster
IMPORTANT:
Release all air from
blaster when not in use.
RESET BUTTON
B. Insert the fully loaded clip from the left
side of the blaster with the arrowheads
pointing right.
a
Align to blaster as shown.
b
Click!
TOP VIEW
D. Pull trigger and release quickly for single fire.
E. Pull and hold trigger for rapid fire.
PERFORMANCE TIPS
5
If rapid fire suddenly stops, try doing the following:
Check if the remainder of the clip is loaded. Rapid fire will stop at empty slots. Press and release
A.
RESET button to advance to loaded slots, then pull and hold trigger to continue firing.
a
Pump sliding handle again until there is resistance, then pull and hold trigger to continue firing.
B.
IMPORTANT INFORMATION
IMPORTANT INFORMATION
Read Carefully!
Read Carefully!
b
2
3
Loading...