Fisher Paykel OB60S Installation Manual
Installation instructions
Multifunction ovens
OB60 models
NZ AU GB IE SG
Important!
SAVE THESE INSTRUCTIONS
The models shown in this document may not be available in all markets and are subject to change at any time. For current details about model and specification availability in your country, please visit our
local website listed at the end of this document or contact your local Fisher & Paykel dealer.
1
SAFETY AND WARNINGS
WARNING!
Electrical shock hazard
Always disconnect the appliance from the mains power supply before
carrying out any maintenance or repairs.
Connection to a good earth wiring system is essential and mandatory.
Alterations to the domestic wiring system must only be made by a
qualified electrician.
Failure to follow this advice may result in electrical shock or death.
WARNING!
Fire hazard
Do not use adapters, reducers, or branching devices to connect this appliance to
the mains power supply.
Failure to follow this advice may result in overheating, burning, or fire.
Important safety instructions!
To avoid hazard, follow these instructions carefully before installing or using this appliance.
Please make this information available to the person installing the appliance - doing so could reduce
your installation costs.
This appliance must be installed and connected to the mains power supply only by a suitably qualified
person according to these installation instructions and in compliance with any applicable local
building and electricity regulations. Failure to install the appliance correctly could invalidate any
warranty or liability claims.
If the power supply cable is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified person in order to avoid a hazard.
WARNING!
Cut hazard
Take care - panel edges are sharp.
Failure to use caution could result in injury or cuts.
2
PRODUCT & CABINETRY DIMENSIONS
OB60S & OB60N MODELS
Installation diagrams for
illustration purposes only
C
E
B
L
I
I
I
K
I
J
J
D
A
H
F
L
16-20 mm
G
2.5 mm
Product dimensions (mm)
A overall height* of product
B overall width of product
C overall depth of product (excluding handle and knobs)
D height of chassis
E width of chassis
F depth of chassis
depth of oven frame and control panel
G
(=distance between front of chassis and front of oven door, excl. knobs)
depth of oven door when fully open
H
control panel)
I minimum inside width of cavity
IIoverall width of cavity
J inside height of cavity
JIoverall height of cavity
K minimum inside depth of cavity
L flush fitting cabinetry clearance
Note: If installing a cooktop above the oven, ensure adequate clearance is provided for the cooktop as per the cooktop
manufacturer’s instructions.
*All height measurements include mounted feet.
** If  tting the lower trim extension kit, the overall height of product (A) increases by 25 mm (to 475 mm).
The height of the cavity (J and Ji) therefore needs to be increased by 25 mm also (to 465 mm and 480 mm respectively).
(measured from front of
OB60S
597 450**
595 595
565 554
582 436
556 536
545 534
20 20
435 289
560 560
600 600
585 440**
600 455**
550 550
20 20
OB60N
OB60B & OB60D MODELS
C
B
E
A
L
H
D
I
H
F
G
Product dimensions (mm)
A overall height* of product
B overall width of product
C overall depth of product (excluding handle and knobs)
D height of chassis
E width of chassis
F depth of chassis
depth of oven frame and control panel
G
(=distance between front of chassis and front of oven door, excl. knobs)
depth of upper oven door when fully open
H
(measured from front of control panel)
depth of lower oven door when fully open
I
H
(measured from front of control panel)
I minimum inside width of cavity
IIoverall width of cavity
J inside height of cavity
JIoverall height of cavity
K minimum inside depth of cavity
L flush fitting cabinetry clearance
*All height measurements include mounted feet.
I
I
I
I
J
J
K
16-20 mm
L
2.5 mm
OB60B
888 1077
595 595
565 565
874 1057
556 556
545 545
20 20
261 435
435 450
560 560
600 600
877 1065
893 1082
550 550
20 20
OB60D
LOWER TRIM
OVEN DOOR
LOWER TRIM
AIR FLOW
3
E
N
L
1
(L )
2
E
N
L
1
(L )
2
Green & Yellow
(Earth)
Brown (Live)
Blue (Neutral)
N
L
PRIOR TO INSTALLATION
5
ELECTRICAL CONNECTION
Before you install the oven, make sure that
the benchtop and oven cavity are square and level, and are the required dimensions
the installation will comply with all clearance requirements and applicable standards and regulations
a suitable isolating switch providing full disconnection from the mains power supply is incorporated in
the permanent wiring, mounted and positioned to comply with the local wiring rules and regulations.
The isolating switch must be of an approved type and provide a 3 mm air gap contact separation
in all poles (or in all active [phase] conductors if the local wiring rules allow for this variation of the
requirements)
the isolating switch will be easily accessible to the customer with the oven installed
there is at least 1.5 m (and not more than 2 m) free length of power supply cable within the cavity for
ease of installation and servicing
the oven connection socket (if fitted) is outside the cavity if the oven is flush to the rear wall
the oven will rest on a surface that can support its weight
the height from the floor suits the customer
you consult local building authorities and by-laws if in doubt regarding installation.
Important!
Some environmental factors and cooking habits can cause condensation in and around the oven during use.
To protect surrounding cabinetry from possible damage caused by frequent or excessive condensation, we
recommend moisture-proofing the oven cavity.
4
UNPACKING THE OVEN
Important!
Do not lift the oven by the door handle.
Important!
This oven must be connected to the mains power supply only by a suitably qualified person.
This oven must be earthed.
Before connecting the oven to the mains power supply, check that
the domestic wiring system is suitable for the power drawn by the oven
(as specified on the rating plate)
the voltage corresponds to the value given on the rating plate.
OB60S & OB60N MODELS
Model code Power Voltage
OB60SLC...
OB60SLM...
OB60SCE...
OB60SCM...
OB60SCT...
OB60SDT...
OB60S9D...
OB60SV...
OB60NL...
OB60NC...
OB60ND...
2350-2550 W 230 - 240 V~
3070 W 220-240 V~
3070 W 220-240 V~
3070 W 220-240 V~
3600 W 230 V~
3600 W 230 V~
3400 W 220-240 V~
3070 W 220-240 V~
2050 W 220-240 V~
2800 W 220-240 V~
2800 W 220-240 V~
1
Unhook to open cover
2
Unscrew to open
cable clamp
Remove all packaging and dispose of it responsibly. Recycle items that you can.
Place the unpacked oven onto wooden blocks or similar supports to prevent damaging the lower trim.
You may remove the feet, but ensure the oven does not sit on the lower trim
Important!
The lower trim ensures correct air circulation and allows the door to open and close without obstruction. The
manufacturer does not accept any responsibility for damage resulting from incorrect installation.
FEET
OB60B & OB60D MODELS
Model code Power Voltage
OB60BC...
OB60BD...
OB60B77C...
OB60B77D...
OB60DD...
5800 W 220 - 240 V~
5800 W 220 - 240 V~
5850 W 220 - 240 V~
5850 W 220 - 240 V~
6120 W 220 - 240 V~
1
Unscrew to
remove cover
plate
2
D
Unscrew to remove
cable clamp
Loading...