Fisher & Paykel HS60CSX3, HS60CSRX3, HS90CIWX3, HS90CSX3, HS60CIWX3 User Manual
Slideout rangehood
HS60CIWX3, HS90CIWX3,
HS60CSX3, HS90CSX3,
HS60CSRX3 models
Installation instructions
and User guide
NZ AU
Contents
Safety and warnings 1
Installation instructions 2
Getting started quickly 5
Cleaning and maintenance 6
Manufacturer’s Warranty 8
Customer Care 9
Important!
SAVE THESE INSTRUCTIONS
The models shown in this User Guide may not be available in all markets and are
subject to change at any time. For current details about model and specification
availability in your country, please visit our local website listed on the back cover
or contact your local Fisher & Paykel dealer.
Safety and warnings
Important!
Please read the entire set of instructions before installing the rangehood.
This appliance can be used by children aged from 8 years and above and persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or
instruction concerning use of the appliance in a safe way and understand the hazards involved.
Children shall not play with the appliance. Cleaning and user maintenance shall not be made by
children without supervision.
The installation of Fisher & Paykel rangehoods must comply with the information in this guide. Failure
to install the rangehood in accordance with these installation instructions may result in electrical
hazards, injury, and damage to your appliance and loss of warranty. Failure by the installer to install
the screws or fixing devices in accordance with these installation instructions may result in electrical
hazards. Please install the appliance as detailed in these instructions.
There must be adequate ventilation of the room when the rangehood is used at the same time
as appliances burning gas or other fuels. (A partial vacuum in the room could result in too high a
concentration of gas in the air).
You must read the details concerning the method and frequency of cleaning.
There is a fire risk if cleaning is not carried out in accordance with the instructions.
Do not flambé under the rangehood.
Exhaust air must not be discharged into an existing flue that is used for exhausting fumes from
appliances burning gas or other fuels.
The minimum distance between the cooktop surface and the filters of the rangehood shall be
600 mm, or 650 mm if installed over a gas cooktop.
Attention should be given to ensure that any applicable regulations concerning the discharge of
exhaust air is fulfilled.
If the supply cord of this equipment is damaged it must only be replaced by the manufacturer, its
service agent or similarly qualified person in order to avoid a hazard.
Always switch the power off prior to installation, servicing or cleaning the rangehood.
Never use the rangehood without the filters in place.
Stainless steel or powdercoat is very easily damaged during installation if abraded or knocked by
tools. It is recommended to protect the top of the rangehood with cardboard or plastic bag during the
installation to minimise the risk of damage occurring.
A power outlet should be within 750 mm of the motor assembly and can be either on the wall, behind
the chimney or in the ceiling.
To comply with electrical safety regulations, this rangehood must be plugged into a socket near the
appliance. The socket must be accessible, or have an accessible isolating switch, to enable the end user
to isolate the rangehood from the power for the purpose of internal cleaning or maintenance.
Ducting accessories are not supplied. All ducting must comply with local requirements and building codes.
1
8.9 kg
(HS60)
kg
(HS90)
WARNING!
Electrical Shock Hazard
All electrical work must be done in accordance with local and/or national
electrical codes as applicable. For safety, this product must be earthed. If
you are unfamiliar with methods of installing electrical wiring, employ the
services of a qualified electrician. Turn off power at service entrance before
installing wiring or servicing this product.
WARNING!
Weight Hazard
The rangehood is heavy. Please ensure adequate care is taken when installing
the rangehood to prevent personal injury. The rangehood must be installed
onto a solid wall, stud, beam or truss. Weight of the product is 8.9 kg (HS60) /
10.8 kg (HS90).
2
Installation instructions
Thank you for purchasing a quality Fisher & Paykel rangehood. Each rangehood is tested and
approved before it leaves the factory, ensuring our high standard of quality control is met.
Contents of packaging
1 x rangehood
1 x installation instructions
1 x Installation kit - “TOP FIXING”
4 x Screw M6 x 40 mm (incl. washer)
6 x Screw 3 x 12 mm
2 x Spacer Rear
2 x Spacer Lateral
HS60CSRX3
All of above and including:
2 x charcoal filter
1 x 40 mm SS handle
HS60CIWX3
All of above and including:
1 x 40 mm white glass handle
HS90CIWX3
All of above and including:
1 x 40 mm white glass handle
HS60/HS90CI
All of above and including:
1 x Vent Duct (Dia. 120mm)
HS60/HS90CS
All of above and including:
1 x Vent Duct (Dia. 120 mm) – top extraction
1 x Vent Duct (Dia. 100 mm) – rear extraction
2 x covers for extraction hole (Dia. 120 mm, Dia. 100 mm)
Typical equipment required
Electric drill
Screwdriver
Duct tape (if ducting)
Jig saw (if ducting)
Ladder (if ducting)
Ducting
Tape measure
Drill bits
Spirit level
0
5
3
85
/
3
5
5
0
5
280
475
Fig.1 Slideout rangehood
210
280
33
1
8
1
4
1
Accessories
Accessory Part Number
Replacement aluminium filter (HS60) 792391
Replacement aluminium filter (HS90) 792392
Charcoal filter (HS60 / 90) 792390
Light bulb 792393
Alternative handle, white glass (HS60) 792394
Alternative handle, white glass (HS90) 792395
Loading...