RM-6000 Remote Control System
INSTALLATION SHEET
Includes: Antenna
1) Transmitter
1) Receiver module with antenna
One Year Warranty!!
This unit is equipped with an automatic 4 hour shut off. It must be turned on with the transmitter after shut off.
This RM-6000 Automatic Operating System package is specifically designed for the 6004 AND 6004-AS fiber optic illuminators and should not be modified or adapted in any way. This is an electric component and should only be installed by a qualified technician. Please follow the instructions carefully. RANGE IS APPROXIMATELY 75 FEET DEPENDING ON CONDITIONS.
1 Locate the 6 Pin Connector
DANGER: TURN OFF ELECTRIC SERVICE TO THE ILLUMINATOR FIRST! 
Remove the two screws securing the cover and remove the cover. Inside the Lifetime IlluminatorTM 
chassis is a 6-pin plastic connector. Locate the connector and unplug it. This is where the RM-6000 
will connect. 
2 Slide the RM-6000 into the chassis and plug it in
Slide the RM-6000 into the two slots on the left side of the chassis with the wires facing the FRONT. Plug together the 6-pin connectors (note that the connectors only fit together one way). Secure the wires in the chassis so the fan and color wheel are not blocked.Take the single antenna wire and attach it to the top of the illuminator chassis with a small piece of electrical tape.
3 Change the toggle switches
Replace the cover on the illuminator. Look at the toggle switch label on the rear of the illuminator and move the toggle switches to their correct position-
Power - bottom position Color - middle position
Turn the power back on and test the unit for proper operation by pressing the ON button for power, and the START button for color wheel rotation.
4 Transmitter
Replacement Battery Type: Std. 9V
INCLUDED!
BATTERY
TOGGLE SWITCH POSITIONS
OPTIONAL RM-6000 CONTROL
COLOR WHEEL |
POWER |
Lamp "Restrike"
When turning the system off and then turning it immediately back on, it may take 1 to 3 minutes before the lamp comes back on.
This process allows the lamp to cool down and then restart.
This is a normal function of the Metal-Halide lamp system that the Fiberstars Lifetime
6000 series uses.
PM 10140 Rev. H
www.fiberstars.com
Loading...