Fiberstars LNS-2GI User Manual

Contents

1) LENS HOUSING

1) Cut the 1 1/2" pipe 1" back from flush to the wall (FIG. A). Remove
any burs from the pipe and glue the lens housing into the end (FIG.B and
FIG.C).

FIG. A

LNS-2GI LENS HOUSING

LENS HOUSING

FIG. B

FIG. C

Refer to KL2-SF or KL2-PF lens kits for lens installation instructions.

2) Run the fiber optic cable through the housing and the pipe, and seat
the lens gasket and lens into the housing.

3) Thread the lens retaining ring into the housing, then use a lens tightening
tool (P/N FS-117) to tighten the lens down.

4) Trowel plaster or pebble material up to the end of the housing near the
lens until the housing is barely seen. Be sure to wipe any material off the
clear lens.

p/n 71-15010-00 REV. A

44259 NOBEL DRIVE FREMONT , CA 94538 [phone] F AX [phone] www .fiberstars.com