Fiberstars LNS-2G User Manual

Contents

1) LENS HOUSING

LNS-2G LENS HOUSING

LENS HOUSING

This lens assembly should glue directly on 1 1/2" PVC pipe. DO NOT GLUE A
REDUCER BUSHING INTO THE LNS-A! If you want to reduce to 1" PVC
pipe, do so with a reducer after a few inches of 1 1/2" PVC pipe. This is to allow
room for the lens assembly to seat into the body of the lens housing.

FIG. A

FIG. B

1) Cut the pipe as flush to the pool wall as possible. Remove any burs
from the and glue the lens housing on the end (FIG.A and FIG. B).

2) Glue 1 1/2" pipe in to the lens housing (FIG. C) and run the pipe to the
illuminator location. Use sweep elbows or heat bend the PVC to allow easy
fiber installation.

Refer to KL2-SF or KL2-PF lens kits for lens installation instructions.

3) Run the fiber optic cable through the housing and the pipe, and seat the
lens gasket and lens into the housing.

4) Thread the lens retaining ring into the housing, then use a lens tightening
tool (P/N FS-117) to tighten the lens down.

p/n 71-15009-00 REV. A

44259 NOBEL DRIVE FREMONT , CA 94538 [phone] F AX [phone] www .fiberstars.com