Fiberstars LNS-2A User Manual

FLW-A Feature Light
for fiberglass/acrylic pools

CONTENTS

1) Feature Light fixture 1) Centering Device (A9904)

1) Broadcast Lens (B11458) 1) Centering Disc (A9787)

1) Large lens o-ring (22-15006-00)

1) Small lens o-ring (A8891)

1) LNS-2A Lens Assembly

1) Adapter Bushing

USE A FEW WRAPS OF TEFLON TAPE AROUND THE THREADS OF THE LENS!

LNS-2A Contents:

1) LENS HOUSING

1) HOUSING NUT

3) GASKETS

INSTRUCTIONS

1) Cut a 2 3/8” hole in the acrylic of fiberglass wall. Place one of the
rubber gaskets on the lens housing as shown and place the housing
in the hole from the inside (FIG A).

2) On the outside of the wall, place the other rubber gasket on the lens
housing then follow it with the paper gasket (FIG B). Thread the
nut onto the housing and tighten with a wrench.

3) Glue 1 1/2” pipe in to the lens housing and run the pipe to the
illuminator location. Use sweep elbows or heat bend the PVC to
allow easy fiber installation.

4) Use a few wraps of Teflon tape around the bushing and thread it
into the lens housing. Use FS-117 lens tool to tighten the bushing
into the housing. Run the fiber optic cable through the Feature
Light fixtures, then through the bushing and lens housing (FIG C).

5) Place the large o-ring on the lens, making sure it seats on the flange
(FIG D). Place the small o-ring in the groove at the base of the
lens, and use a few wraps of Teflon tape around the threads of the
lens. Thread the lens into the fixture and tighten it snugly. Thread
the lens into the housing, then use a FS-117 lens tightening tool to
tighten the lens down to the feature light. Do not over tighten.

6) Apply a generous amount of silicone to the stub on the Feature
Light and insert it into the bushing. Make sure the Feature Light is
level.

HOUSING NUT

GASKETS

LENS HOUSING

5” – 7” below water level

FIG. D

PM10101, Rev. D

44259 NOBEL DRIVE FREMONT, CA 94538 [phone] FAX [phone] WWW.FIBERSTARS.COM