Fiat Bravo 2008 User Manual

Page 1
FIATBRAVO
VAN
Page 2
VARIANTS COMPARED WITH THE OWNER HANDBOOK
This version is available in a 5-door, 4-seater version with a partition wall between the passenger compartment and the load compartment fig. 1.
As far as anything not contained in this Supplement is concerned, refer to the Owner Handbook to which this Sup­plement is attached.
fig. 1
4 SEATER VERSION
The vehicle is equipped with:
Rear seat with two seats only with
three point reel seat belt.
Fixed tubular wall with separation
between luggage compartment and passenger compartment.
F0Q0780m
fig. 2
F0Q0781m
SEAT BELTS
On the four-seater version, there are two three point seat belts with reels for the rear seats fig. 2.
22
Page 3
PRESETTING FOR MOUNTING THE “UNIVERSAL ISOFIX” CHILD RESTRAINT SYSTEM
WARNING
Per questo allestimento il
Codice della Strada pre­scrive il divieto di NON trasportare bambini, a prescindere del sistema di ancoraggio (“Isofix” o tramite seggiolini e cinture). Tale limite è esteso anche ai sedili an­teriori e assenza di sistema fissag­gio “Isofix”.
LOADING ADVICE
The vehicle has been designed and ho­mologated according to given maxi­mum weights:
kerb weight
payload
total weight
maximum weight on the front axle
maximum weight on the rear axle
towable weight.
Each of these limits must be borne in mind and never, under any circum­stances, exceeded.
Other simple measures can improve driving safety, driving comfort and the life of the vehicle:
distributing the load evenly over the
floor. If it must be concentrated in a single area, choose the middle sec­tion between the two axles;
remember that the more the load
is in a low position, the vehicle cen­tre of gravity will become lower, fa­cilitating safe driving: therefore al­ways position the most heavy goods at the bottom;
remember that the dynamic behav-
iour of the vehicle is affected by the weight transported: in particular, the stopping distances increase, es­pecially at high speed
WARNING
In the case of sharp braking
or impacts, one sudden movement of the load could create a dangerous situation for the driver or the passenger: before settting off, make sure that the load is properly secured using the partition and, where fitted, the special hooks; use suitably strong wire, cables or belts for the weight of the material to be secured.
3
Page 4
ENGINE CODE - BODYWORK VERSIONS
Engine code Bodywork versions
1.6 Multijet 105HP 198A3000 198BXH1B AX (*)
198BXH1B BX (**)
(*) Versions without DPF
(**) Versions with DPF
PERFORMANCE
Top speed fully laden: 187 km/h
4
Page 5
DIMENSIONS
VAN 4 seats
Length mm 4336
Width mm 1792
Height with no load mm 1498
Projection:
Front mm 974 Rear mm 762
Wheelbase mm 2600
Track:
Front mm 1538 Rear mm 1532
Load compartment
Maximum Length mm 793
Maximum Width mm 1022
Maximum heigth mm 812
Load compartment volume dm
3
400
5
Page 6
WEIGHTS
Weights (kg) 1.6 Multijet 105HP
Weight empty (with all fluids, fuel tank 90% full, without optional equipment): 1315
Carrrying capacity including the driver (**): 505
Maximum permitted loads (**) – front axle 1060 – rear axle 870 – total 1820
Loads that can be towed (***): – braked tailer 1300 – not braked trailer 500
Maximum load on the ball (braked tailer): 60
Maximum load on the roof 80
(*) If special equipment is fitted (sun roof, trailer towing equipment, etc.) the unladen weight will increase and consequently the payload
will decrease in relation to the maximum permitted loads.
(**) Loads not to be exceeded. The user is responsible for arranging goods in the luggage compartment and/on load carrying platform
within the maximum permitted loads.
(***) Respect the speed limits in each country for vehicles towing a trailer. The maximum speed should not exceed 80 km/h.
6
Page 7
FUEL CONSUMPTION
CONSUMPTION IN ACCORDANCE WITH DIRECTIVE 2004/3/EC (litres per 100 km)
1.6 Multijet 105HP
Urban 6.3
Extra urban 4.1
Combined 4..9
CO2 EMISSIONS
The CO2emission figures refer to combined consumption.
EMISSIONS IN ACCORDANCE WITH DIRECTIVE 2004/3/EC
CO
2
1.6 Multijet 105HP: 129 g/km
7
Page 8
Fiat Group Automobiles S.p.A. Customer Services - Technical Services - Service Engineering Largo Senatore G. Agnelli, 5 - 10040 Volvera - Torino (Italia)
Print n. 603.83.970 - 06/2008 - 1
st
Edition
Loading...