Fenix ECOSUN S+, ECOSUN S+ ANTICOR Instructions For Use And Installation

Instructions for use and installation

Radiant electric heating panel: ECOSUN S+

ECOSUN S+ ANTICOR

1. Basic technical data

* version Ecosun S+

2. Use

Radiant panels are intended for the heating of large spaces, mainly industrial halls and workshops, etc., warehouses, shops, function halls

and sports halls. They can also be used for the local heating of designated areas (zonal temperature maintenance).

The Ecosun S+ ANTICOR model is intended for environments with an increased risk of corrosion.

The panel is constructed for use in environments with splashing water. However, rapid cooling of the panel when it is hot can result in

irreversible damage to it.

3. Installation

Installation of these panels may only be carried out by a person with a specialized qualification. The electrical

wiring must comply with the valid norms in the country of installation. The panels can either be hung from the

ceiling on four fixtures using a chain or cords, or with the help of installation brackets. The brackets are

supplied disassembled in the terminal and need to be attached before installation of the panel. The brackets

can be supplemented with a swivel bracket – an inclinable bracket (not part of the product package).

The radiant panel can be installed at an angle as well as vertically. However it must not be installed at an

angle or vertically in such a way that the terminal is the highest part of the panel. There is higher convection

of heat when the panel is in a tilted position and this heat would irreversibly damage the electrical compo-

nents of the terminal.

N529/R02 (02.10.13)

Type

Wattage

W

Voltage

V

Protection

class

IP

Dimensions

mm

Weight

kg

ECOSUN S+ 06 * 600

230/400V 3N

I IP 44

650 x 250 x 60

ECOSUN S+ 08 *

850

ECOSUN S+ 09

900

230 V 1N 1550 x 150 x 60 7,8

ECOSUN S+ 12 1200
ECOSUN S+ 18 1800

230/400V 3N

1550 x 250 x 60 12,35

ECOSUN S+ 24 2400
ECOSUN S+ 30 3000

1550 x 350 x 60 16,65

ECOSUN S+ 36 3600

4,9

Installation using a fixing bracket

•

Attach the mounting frame so that the opening for the positioning screw is accessible. Slide one side of the panel onto the holder.

• Slide the panel onto the other part of the holder and secure it with a screw.

Typ Spacing Note

ECOSUN S+ 06

100 x 300

− diameter of the opening in the brackets: 6 mm

− when handling the panel, it is not advisable to

touch its radiant surface with dirty hands

ECOSUN S+ 08
ECOSUN S+ 09
ECOSUN S+ 12
ECOSUN S+ 18

100 x 1000

ECOSUN S+ 24
ECOSUN S+ 30

200 x 1000

ECOSUN S+ 36

40 x 1000

Spacing of grips at the back side of the panel:
After insertion, it is advisable to secure it in position with the use of
positioning screws to prevent it from sliding out.

• Clearance distances from flammable objects:

from the radiant surface (temperature up to 380°C): 100 cm
from the top edge at the distance of the mounting brackets
from other parts of the panel: 25 cm

• Lowest height above the floor: 350 cm (recommended value)

• The mutual distance between panels is usually greater than the

height of their installation above the floor

•The panel must not be placed directly under an electric socket.