PUGILIST DISTORTION
14
LEDs
5
TONE A GAIN A TONE B GAIN B
4
3
2
PUGILIST DISTORTION
1
9V DC
INPUT
6 7 8 9
SERIES
BLEND
A B
BLEND
BOOST
BASS
LEVEL
15
10
11
12
13
1. Bypass Footswitch
2. Jewel Indicator
3. Output Jack
4. Blend Knob
5. Tone A
6. Gain A
7. Blend/Series Switch
8. Bass Boost Switch
9. Tone B
10. Gain B
11. Level Knob
12. Input Jack
13. Low Battery Indicator
14. LED Kill Switch
15. DC Power Connector
PUGILIST DISTORTION
Thanks for purchasing the Pugilist Distortion—a
flexible distortion pedal with a wealth of tones. The
Pugilist is somewhat unusual in that it features two
separate distortion engines (A and B) that can be
blended together or stacked in series for extreme
gain. Each distortion engine can be adjusted with its
own gain and tone settings so that, for example, a
cleaner tone can be blended with a much more
distorted sound (the benefit being that the cleaner
tone adds clarity and articulation to the overall
sound). Also, blending two high-gain tones can
increase richness and complexity compared to a
single-distortion-only sound. The Pugilist features
simple wide-ranging tone controls that let it work
well with a variety of amp types.
DESIGNED IN CALIFORNIA, U.S.A.
Gain (A and B)
This control adjusts the amount of gain (or drive) in the A and B
distortion engines. Counterclockwise settings are cleaner, with slightly
less volume. Clockwise settings have more sustain and saturation.
Individual notes in chords are easier to hear with lower gain settings,
which is why mixing two sounds together is so much fun—great clarity
and power simultaneously. The A distortion engine offers less gain
than the B engine and gets cleaner tone; the B engine reaches into
high-gain territory at extreme settings.
Tone (also applies to Tone B)
This control affects the amount of high-frequency (treble) content in the
final sound. Counterclockwise settings are darker. Clockwise settings
add brightness. Set this control to preference (depending on whether
the effect is connected to a bright, clean amp; an already-distorted
warmer amp or something else entirely) and experiment to see what
works best.
Blend/Series Switch
The Blend/Series switch controls whether the two distortion engines
are running in parallel with the ability to blend between them, or
whether they are running in series for very high gain settings. Note
that the Blend control knob is disabled when this switch is placed in
the series (up) position. This is normal.
Blend Knob
The Blend control knob controls how much of each distortion engine is
heard when in Blend mode. When fully counterclockwise, only the A
distortion engine is heard. When fully clockwise, only the B distortion
engine is heard. A midway setting delivers a 50/50 mix of both
engines. Try experimenting with cleaner and brighter A engine
settings, and more distorted and warmer B engine settings for
complex tone that works well for many different types of playing.
Bass Boost Switch
The Bass Boost switch increases tonal “fatness” by adding a healthy
dose of extra bass and lower-midrange energy. Players might want to
turn this switch off (down) when playing through an already-distorted
amp, and on (up) when playing through a totally clean amplifier.
Level Knob
The Level control knob adjusts the pedal’s final output volume.
Jewel Indicator
The Jewel Indicator shows when the distortion effect is active.
Bypass Footswitch
This rugged footswitch is used to bypass the effect (true-bypass
design).
Input Jack
This is a high-impedance input suitable for electric guitar, bass,
acoustic guitars with pickup systems, keyboards and other instruments.
Output Jack
This is a low-impedance output jack that connects to the amp or to the
next effect pedal in the signal chain.
DC Power Connector
This is a standard center-negative 9VDC jack for use with appropriate
power supplies.
LED Kill Switch
This switch extinguishes the LEDs that illuminate the knobs—useful in
maximizing battery life when running the pedal from batteries.
Low Battery Indicator
This red LED on the front of the battery door illuminates when battery
voltage drops below a set threshold, indicating that the battery should
be replaced soon.
FENDER MUSICAL INSTRUMENTS CORPORATION
A PRODUCT OF:
CORONA, CALIFORNIA, USA
Fender® is a registered trademark of FMIC.
Copyright © 2018 FMIC. All rights reserved.
P/N 7713293000 - REV A
Important Safety Instructions
•WARNING: To prevent damage, fire or shock hazard, do not expose the unit or its AC
power to rain or moisture.
•Do not alter the AC plug of the connected power adapter
•Do not drip or splash liquids on the unit.
•No user serviceable parts inside, refer servicing to qualified personnel only.
• WARNING: The unit must only be connected to a safety agency certified, regulated,
power source (adapter), approved for useand compliant with applicable local and
national regulatory safety requirements.
• Unplug the AC power adapter before cleaning the unit exterior. Use only a damp cloth
for cleaning and then wait until the unit is completely dry before reconnecting it to power.
• Amplifiers and loudspeaker systems, and ear/headphones (if equipped) are capable
of producing very high sound pressure levels which may cause temporary or permanent
hearing damage. Use care when setting and adjusting volume levels during use.
THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES. OPERATION IS SUBJECT TO
THE FOLLOWING TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL
INTERFERENCE, AND (2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED,
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION.
Languages
Manual available in Espanol, francais, Italiano, Deutch, Portugues, (Chinese)
www.fender.com/support
Expanded Owner’s Manual
Expanded Owner’s Manual available at:
www.fender.com/support
Specifications
IMPEDANCES:
POWER SUPPLY:
POWER REQUIREMENTS:
DIMENSIONS:
WEIGHT:
Product specifications subject to change without notice
INPUT: 1MΩ OUTPUT LOAD: >10kΩ
One 9V battery or 9VDC regulated adapter,
5.5 x 2.1 mm barrel connector, center negative
22mA @ 9VDC
88mA Total Current Consumption
3.75” x 4.9” x 2.5” (95.25mm x 124.5mm x 63.5mm)
1.2lbs (.54kg)
NOTES:
© FENDER MUSICAL INSTRUMENTS 2018
Loading...