INSTRUCTION MANUAL
VACUUM CLEANER
FC285H
Contents
IMPORTANT SAFETY INSTRUCTIONS
NAMES OF EACH PART
PREPARATION BEFORE USE
USING THE VACUUM CLEANER
USING THE ATTACHMENTS
EMPTYING THE DUST COMPARTMENT
CLEANING THE FILTERS
CLEARING BLOCKAGES IN THE
SUCTION HOSE AND CLEANING THE
AGITATOR ASSEMBLY
REPLACEMENT INSTRUCTIONS
FILTER SENSOR
TROUBLESHOOTING
REPLACEMENT PARTS
LIMITED WARRANTY
1
3
4
6
8
10
11
12
13
16
17
17
18
HOUSEHOLD AND COMMERCIAL USE
IMPORTANT SAFETY INSTRUCTIONS
When using an electrical appliance, basic precautions should always be
followed, including the following.
READ ALL INSTRUCTIONS
BEFORE USING THIS VACUUM CLEANER
WARNING - To reduce the risk of fire, electric shock or injury:
1. Do not leave the vacuum cleaner when plugged in. Unplug it from the outlet
when not in use and before servicing.
2. Do not use outdoors or on wet surfaces.
3. Do not allow vacuum cleaner to be used as a toy. Close attention is necessary
when used by or near children or infirmed persons.
4. Use only as described in this manual. Use only the manufacturer's
recommended attachments.
5. Do not use with a damaged cord or plug. If the vacuum cleaner is not working
as it should, or if it has been dropped, damaged, left outdoors or dropped into
water, return to FANTOM at 94 Main Mill Street, Door 16, Plattsburgh, NY 12901.
6. Do not pull or carry by the cord, use the cord as a handle, close a door on the
cord, or pull the cord around sharp edges or corners. Do not run the vacuum
cleaner over the cord. Keep the cord away from heated surfaces.
7. Do not unplug by pulling on the cord. To unplug, grasp the plug, not the cord.
8. Do not handle the plug or the vacuum cleaner with wet hands.
9. Do not put any objects into the openings. Do not use with any opening
blocked, keep free of dust, lint, hair and anything that may reduce air flow.
10. Keep hair, loose clothing, fingers and all the parts of your body away from
openings and moving parts.
11. Do not pick up anything that is burning or smoking, such as cigarettes,
matches or hot ashes.
12. Do not use without dust compartment and filters in place.
13. Turn off all controls before unplugging.
14. Use extra care when cleaning on stairs.
15. Do not use to pick up flammable or combustible liquids such as gasoline, or
use in areas where they may be present.
11
Rev. 02/06
16. Do not touch the agitator while it is spinning.
17. Do not place any heavy items on top of the vacuum cleaner.
18. Do not step on the hose or pull it too strongly.
19. Do not pick up items such as pieces of waste paper or cloth which looks as
though they may cause the hose to become blocked.
20. Do not clean or store the vacuum cleaner in places where there are high
temperatures.
21. Store the vacuum cleaner away from excessive humidity.
22. When carrying the vacuum cleaner, hold it by the carrying handle.
23. Before servicing the vacuum cleaner, allow all internal metal parts to cool first.
24. Always place foot on handle release when adjusting the handle position
of the vacuum cleaner.
25. If the supply cord of this appliance is damaged, it must only be replaced by
FANTOM, because special purpose tools are required.
26. Connect to a properly grounded outlet only. See Grounding Instructions.
WARNING:The power cord on this product contains lead, a chemical known to the State of
California to cause birth defects or other reproductive harm. Wash hands after handling.
SAVE THESE INSTRUCTIONS
This vacuum is intended for household or commercial use.
Note to user concerning attachment plug:
Grounding Instructions
This appliance must be grounded. If it should malfunction or breakdown, grounding
provides a path of least resistance for electric current to reduce the risk of electric shock.
This appliance is equipped with a cord having an equipment-grounding conductor and
grounding plug. The plug must be inserted into an appropriate outlet that is properly
installed and grounded in accordance with all local codes and ordinances.
WARNING- Improper connection of the equipment-grounding conductor can result in a risk
of electric shock. Check with a qualified electrician or service person if you are in doubt as
to whether the outlet is properly grounded. Do not modify the plug provided with the
appliance - if it will not fit the outlet, have a proper outlet installed by a qualified electrician.
This appliance is for use on a nominal 120-volt circuit and has a grounding attachment plug
that looks like the plug illustrated below. Make sure that the appliance is connected to an
outlet having the same configuration as the plug.
Grounded
Outlet
2
Grounding
Pin
NAMES OF EACH PART
Handle
Release
Button B
Tool Cover
Carrying Handle
Dust Cup Knob
Filter Cover
FRONT
Release
Button A
ON/OFF Switch
Variable Suction
Control
Dust
Compartment
Power Cord
Plug
Plug shown in figure
may differ from actual
plug attached to unit
for your area.
Cord Storage
Hooks
Suction
Hose A
REAR
Crevice Tool
Power Cord
Wand
Duster
Filter Sensor
Headlight
Set the ON/OFF switch
to " ON " to light the
headlight.
WARNING:
Hose Holder
Upholstery Tool &
Dusting Brush
Rug/Floor (Tools)
SELECTOR
Height Adjustment
Lever
Cleaning Utensil
Suction
Hose B
Handle Release Lever
Extra Hose
Operate vacuum cleaner only at the voltage specified on name plate.
3
PREPARATIONS BEFORE USE
Caution: Do not connect the power cord plug to the wall outlet until assembly
is completed.
Attaching the handle
Set the vacuum cleaner
1
to the upright position.
lnsert the handle
2
as shown in the illustration.
Handle
Attaching the suction hose A,B & attachments
Duster
Crevice Tool
4
Suction Inlet
Hose Cuff
Wand
Suction
Hose A
The wand and crevice
tool are contained
together. Insert the
crevice tool as shown.
Suction
Hose B
Upholstery Tool
& Dusting Brush
PREPARATIONS BEFORE USE
WINDING THE POWER CORD
Wind the power cord around
1
the cord storage hooks.
Secure the power
cord plug on the
power cord.
Cord Storage
Hooks
RELEASING THE POWER CORD
Rotate the upper cord
1
storage hook downward.
Upper Cord
Storage Hook
Return the hook to the
2
upright position before
attempting to rewind
the power cord.
INSERTING THE POWER CORD PLUG
Insert the power cord plug into the
wall outlet.
Plug shown in figure may
differ from actual plug
attached to unit for
your area.
THERMAL SAFETY DEVICE IN MAIN BODY
To protect your vacuum cleaner motor from overheating, a thermal safety device has been
built in. If your vacuum cleaner hose or air intake clogs up with dust or dirt, or if your dust
bag becomes full and you continue to run the machine, the vacuum will shut off
automatically to prevent the motor from overheating. If this happens, turn off switch and
disconnect your vacuum from power outlet, remove the material clogging the machine
and let your vacuum cool down for approximately 45 minutes. You can then restart your
vacuum cleaner and use it again.
5