Fantech MV132, MV112, MV202, MV204, MV254 Installation & Maintenance Instructions Manual
...
MINITUBE, MINIVENT &
RING PLATE
INSTALLATION & MAINTENANCE
INSTRUCTIONS
INSTALLATION & MAINTENANCE
ABB
INSTRUCTIONS
1. Check fan for possibility of transit damage.
2. Ensure that the duct is clear of any debris that
could be drawn into the fan impeller.
3. Check the fan is free to rotate.
4. Wiring diagrams are provided on all fans.
5. Fans 202 to 356 have automatic self resetting
thermal cut-out switches incorporated in the motor
as standard. Except for the Minitube range which
are fitted with a manual reset thermal overload
device.
6. All fans are provided with sealed-for-life bearings
and are virtually maintenance free.
7. Connections, cables and cords must be installed in
accordance with local regulations. This product
must be installed by a licensed Electrician.
8. The Licensed Electrical installer must ensure that
an approved means of disconnection be
incorporated into the fixed wiring.
9. This appliance is not intended for use by young
children or infirm persons unless they have been
adequately supervised to ensure that they can use
it safely. Young children should be supervised to
ensure that they do not play with the appliance.
10. For duct or partition mount, precautions must be
taken to avoid the back-flow of gases into the room
from the open flue of gas or other open-fire
appliances.
11. The Minitube range of duct fans must be fitted with
a minimum of 1m of duct to both inlet and outlet
spigots.
12. After starting check:-
For excessive vibration
Full load Amps and ensure they do not exceed the
nameplate Amps.
MINIVENT ROOF UNITS - MODELS MV112 - MV356
All Minivent axial roof units can be mounted directly onto
roofs pitched up to 30°.
On the MV200, MV250 and MV300 series fans the top cap
must be removed to access the electrical junction box.
Fan Model A B Fan Model A B
MV112 210 25 MV204Ex 350 30
MV132 210 25 MV252/4 350 30
MV182Ex 350 30 MV302/4/6 350 30
MV202/4 350 30 MV354/6 400 50
Loading...