Fantech 1ACC30WH User Manual
Operational and Parts Manual
fantech
1ACC..WH
24” - 60” Wall-Mounted Weatherhoods
Item #: 481804
Rev Date: 082913
United States
10048 Industrial Blvd., Lenexa, KS, 66215
Tel.: 800.747.1762 • Fax: 800.487.9915
Canada
50 Kanalflakt Way, Bouctouche, NB, E4S 3M5
Tel.: 800.565.3548 • Fax: 877.747.8116
2
Note Warning /
Important
Information Technical
information
Practical tip
note
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect
yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage!
Retain instructions for future reference.
Description
Weatherhoods are designed to shield fan and damper openings in walls from rain and snow. A birdscreen is included. Weatherhoods are shipped
unassembled.
Dimensions
C
A Sq.
B
Table 1: Dimensional Data
Model Fan Diameter A B C Side Panel Gage Qty. of Fasteners
1ACC24WH 24 28
1ACC30WH 30 34
1ACC36WH 36 40
1ACC42WH 42 46
1ACC48WH 48 54
1ACC54WH 54 60
1ACC60WH 60 60
Dimensional information is in inches.
1
/
8
1
/
8
1
/
8
1
/
8
1
/
8
1
/
4
1
/
4
21 2 1 18
25 2 1 18
29 2 2 18
33 2 2 18
38 2 2 18
1
44
48
/
2
3
/
8
2 2 18
2 2 18
fantech
Installation
Fan should be securely mounted to wall prior to installation of weatherhood.
Care should be taken to ensure that power source to fan is locked OFF before weatherhood is installed so that the fan creates no hazard to
installer.
1. Fasten front, top, bottom, and side panels together with 1/4 dia. x 1/2” long screws (supplied).
2. On models 1ACC36WH thru 1ACC60WH, fasten the center support angle to the front and bottom panel with 1/4 dia. x 1/2” long screws
(supplied).
3. Fasten the bracket(s) to the front panel with 1/4 dia. x 1/2” long screws (supplied).
4. Fasten the screen to the face of the weatherhood with the 1/4 dia. x 1/2” long screws and 1.0 dia. washers (supplied).
5. Fasten weatherhood directly to the wall (hardware not supplied).
a. Use a 1/4 x 2” masonry anchor for masonry walls.
b. Use 1/4 x 2” lag screws if fastening to a framed wall.
Maintenance
Make certain that the power source is disconnected before attempting to service or disassemble any components! If the power disconnect
is out-of-sight, lock it in open position and tag to prevent application of power.
3
Cleaning
Clean any accumulated dirt which would restrict air ow.
fantech
Loading...