EZWatch Multi View EZ Watch User Manual

GeoVision Technical Handbook

46

4.3 Multiview Setup

 Configure this section on remote PC.

4.3.1 Install Multiview

Multiview can be obtained from one of the following locations:

 Download from GV-DVR system remotely via Internet Explorer.
 Install from GeoVision installation disk.
 Download from http://www.usavisionsys.com/download.

Download from GV-DVR System

1. Under Internet Explorer, type in DVR’s IP address

as found in section 4.2.2. (If connecting within the
same network, use LAN IP address as found in

4.2.1.)

2. Type in ID and Password of the DVR system

3. Click “Login”.

4. Install all ActiveX Control as prompted. (ActiveX

Control options will appear as an orange bar on
top)

5. Click on orange bar as shown below, then select

“Install” or “Run Add-on”.

6. Refresh webpage. (Login may be required).

7. Select “Run” if prompted by Internet Explorer security warning.

GeoVision Technical Handbook

47

8. When one channel view appears on the webpage, click on

“DMMultiView” from the menu list on the left.

9. Select “1024x768” to download Multiview.

 Select higher resolution Multiview only if your desktop

supports such resolution

10. Follow on-screen instruction to finish installing Multiview.

11. Proceed to Section 4.3.2 Run Multiview.

Install from Disk

1. Insert GeoVision Main System Installation Disk in DVD Rom.

2. In the main menu, select “Install GeoVision System”.

GeoVision Technical Handbook

48

3. Select “GeoVision Multi View”.

4. Follow on-screen instruction to finish installing Multiview.

5. Proceed to Section 4.3.2 Run Multiview.

Download from Website

1. In Internet Explorer, go to http://www.usavisionsys.com/download.

2. Click on “Software”.

3. Click on “Multiview”.

4. Click on “Download”.

5. After download, extract the zip file then run Setup.exe to begin setup.

6. Follow on-screen instruction to finish installing Multiview.

7. Proceed to Section 4.3.2 Run Multiview.