EZWatch EZDOME-VP User Manual

DIGITAL VIDEO CAMERA

User's Manual

SKU# EZDOME-VP

Vandal-Proof Night Vision Camera w/ Wall Mount

• Do not point camera directly into light sources

WARNING

Attention: To

resolution 420TVL Minimum

camera; everything needed for user operation is on the surface of the camera;

resolution 420TVL Minimum

illumination 0.0LUX Electronic shutter

Auto:1/50(1/60)-1/100,000Sec S/N ratio

>48dB Gamma 0.45

Ω

Power supply DV 12V±10%

• Avoid installation in unstable places

Temperature: -20

⁰C/+50⁰C

Power supply DV 12V±10%

Power consumption 150mA Daytime, 500mA Night

reduce the danger of electric shock, please do not open the case (or back cover) of
camera; everything needed for user operation is on the surface of the camera;
please seek help from a qualified professional for repair.

• Suggested mounting height 8'-12'

• Do not mount camera directly to a metal surface

Image Sensor 1/3" SONY EXVIEW HAD CCD
Effective Pixels PAL:500(H)x582(V) NTSC:510(H)x492(V)
Sensor area 4.9mmx3.7mm
Signal system PAL/NTSC Horizontal

Attention items:

• Do not touch CCD or lens

• Please ensure correct voltage on power supply

• Do not use camera in the following conditions,

Lens 3.6mm Wide Angle
Video output 1.0Vp-p, 75

Operating Temperature -10⁰C-+50⁰C

Making a BNC Connection

Connecting a Pre-made Cable

Step 1: Strip away all of the cable and shielding so

Connect this end to

Step 2: Then strip away the black outer jacket so

Installing a power wire pigtail

Contact

EZWATCHPRO

www.ezwatch-

strip away about 1/4" of the wires jacket to

EZWATCHPRO

www.ezwatch-

Phone/Fax

Free 1-866-241-3400

International 001-801-4783980 Fax

cable which came with your kit. You should have

1-801-295-2191

Mail

Main Office/Mailing Address

Automated Video Systems

1600 S. State Street

the power cable and twist it together with the all

Salt Lake City, UT 84115

you have 1/2" of the center conductor exposed as
shown in the picture.

the camera.

you have 1/4" of the shielding exposed. Do not
allow any of the copper shielding to touch the
center conductor.

Step 3: Insert the cable into the fitting and gently
find the hole for the center conductor before you
press the fitting onto the wire. Now just twist the
fitting onto the wire while firmly pressing down
until the fitting is firmly on the cable.

Step 1: At the camera location, take the power
cable and strip away the outer sheathing to
expose the inner two wires (black & red). Then

expose the copper wire. Do the same to the
power wire pigtail which connects to the camera
power connection as shown. Note: Do not strip or
cut the power lead coming directly from the
camera. You should strip the "pigtail" power
cable which came with your kit. You should have
one "pigtail" for each camera.

The cables are labeled with a yellow wrap detailing the camera end and the
DVR end. It is very important that you identify these ends before installing

the cable so that you have the correct ends at the correct location.

security-cameras.com

Technical Support/Sales Toll

Step 2: Now take the red power cable lead and
twist it together with the black & white lead from
the power pigtail. Now take the black lead from

black lead from the pigtail. Use the gray wire nuts
provided with your system and twist them onto
the wires until they are firmly secured.

Salt Lake City, UT 84115