EZWatch CD360HVAD-EXSL User Manual

DIGITAL VIDEO CAMERA

User's Manual

SKU# CD360HVAD-EXSL

Vandal-Proof High Resolution

540 Line Dome w/ Varifocal Lens

• Suggested mounting height 8'-12'

• Do not point camera directly into light sources

WARNING

Image Sensor 1/3" SONY EX-VIEW COLOR CCD

Effective Pixels PAL:512(H)x582(V) NTSC:512(H)x492(V)

Sensor area 4.9mmx3.7mm

• Avoid installation in unstable places

the camera; please seek help from a qualified professional for repair.

Electronic shutter Auto:1/50(1/60)-1/100,000Sec

Gamma 0.45

Lens 3.6mm

Ω

IR wave length 850nm

• Avoid installation in unstable places

Power supply Dual Power: AC 24V/DC 12V (+/-10%)

Power consumption 250mA (+/-10%)

• Do not mount camera directly to a metal surface

Attention:

To reduce the danger of electric shock, please do not open the case (or back
cover) of camera; everything needed for user operation is on the surface of

Attention items:

• Do not touch CCD or lens

• Please ensure correct voltage on power supply

• Do not use camera in the following conditions,
Temperature: -10⁰C/+50⁰C

Signal system PAL/NTSC
Horizontal resolution 540TVL
Minimum illumination 0.001LUX/F1.2

S/N ratio >48dB

Video output 1.0Vp-p, 75

Operating Temperature -10⁰C-+50⁰C

Making a BNC Connection

Connecting a Pre-made Cable

Step 1: Strip away all of the cable and shielding so

Connect this end to

Step 2: Then strip away the black outer jacket so

Step 3: Insert the cable into the fitting and gently

Installing a power wire pigtail

Contact

strip away about 1/4" of the wires jacket to

EZWATCHPRO

www.ezwatch-security-cameras.com

strip away about 1/4" of the wires jacket to

www.ezwatch-security-cameras.com

Phone/Fax

Technical Support/Sales

Toll Free 1-866-241-3400

International 001-801-4783980

one "pigtail" for each camera.

Fax [phone]

Mail

Main Office/Mailing Address

Automated Video Systems

1600 S. State Street

the power cable and twist it together with the all

Salt Lake City, UT 84115

you have 1/2" of the center conductor exposed as
shown in the picture.

the camera.

you have 1/4" of the shielding exposed. Do not
allow any of the copper shielding to touch the
center conductor.

find the hole for the center conductor before you
press the fitting onto the wire. Now just twist the
fitting onto the wire while firmly pressing down
until the fitting is firmly on the cable.

Step 1: At the camera location, take the power
cable and strip away the outer sheathing to
expose the inner two wires (black & red). Then

expose the copper wire. Do the same to the
power wire pigtail which connects to the camera
power connection as shown. Note: Do not strip or
cut the power lead coming directly from the
camera. You should strip the "pigtail" power
cable which came with your kit. You should have

The cables are labeled with a yellow wrap detailing the camera end
and the DVR end. It is very important that you identify these ends

before installing the cable so that you have the correct ends at the
correct location.

Step 2: Now take the red power cable lead and
twist it together with the black & white lead from
the power pigtail. Now take the black lead from
the power cable and twist it together with the all
black lead from the pigtail. Use the gray wire nuts
provided with your system and twist them onto
the wires until they are firmly secured.