EZWatch 200AUTO User Manual

DIGITAL VIDEO CAMERA

User's Manual

SKU# 200AUTO

Long Range Exterior Camera

36 LED Units

• Do not mount camera directly to a metal surface

WARNING

WARNING

Attention:

Image Sensor 1/3" SONY CCD & DSP IMAGE SENSOR

Effective Pixels PAL:520(H)x582(V) NTSC:520(H)x492(V)

Minimum illumination 0Lux(IR LED ON)

Electronic shutter Up To 1/100,000Sec

Electronic shutter Up To 1/100,000Sec

Gamma 0.45

Lens Long Range Auto Zoom 8.5-51mm

Ω

IR wave length 850nm

Power supply DV 12V±10%

• Do not use camera in the following conditions,

Power supply DV 12V±10%

+/-10%)

• Do not use camera in the following conditions,

To reduce the danger of electric shock, please do not open the case (or back
cover) of camera; everything needed for user operation is on the surface of
the camera; please seek help from a qualified professional for repair.

• Suggested mounting height 8'-12'

• Do not point camera directly into light sources

Signal system PAL/NTSC
Horizontal resolution 480TVL

Attention items:

S/N ratio >48dB

• Do not touch CCD or lens

• Do not use any unidentified power supply

Video output 1.0Vp-p, 75

• Avoid installation in unstable places

Temperature: -20⁰C/+50⁰C

Power consumption 800mA (
Remote Control Iris Lens/FOCUS/ZOOM

Making a BNC Connection

Connecting a Pre-made Cable

Making a BNC Connection

Connecting a Pre-made Cable

Step 1: Strip away all of the cable and shielding so

Connect this end to

Step 2: Then strip away the black outer jacket so

you have 1/4" of the shielding exposed. Do not

The cables are labeled with a yellow wrap detailing the camera end

find the hole for the center conductor before you

Installing a power wire pigtail

Contact

EZWATCHPRO

www.ezwatch-security-cameras.com

expose the copper wire. Do the same to the

Phone/Fax

Technical Support/Sales

Toll Free 1-866-241-3400

International 001-801-4783980

Fax [phone]

black lead from the pigtail. Use the gray wire nuts

Mail

Main Office/Mailing Address

Automated Video Systems

1600 S. State Street

Salt Lake City, UT 84115

black lead from the pigtail. Use the gray wire nuts

Salt Lake City, UT 84115

you have 1/2" of the center conductor exposed as
shown in the picture.

the camera.

allow any of the copper shielding to touch the
center conductor.

Step 3: Insert the cable into the fitting and gently

press the fitting onto the wire. Now just twist the
fitting onto the wire while firmly pressing down
until the fitting is firmly on the cable.

Step 1: At the camera location, take the power
cable and strip away the outer sheathing to
expose the inner two wires (black & red). Then
strip away about 1/4" of the wires jacket to

power wire pigtail which connects to the camera
power connection as shown. Note: Do not strip or
cut the power lead coming directly from the
camera. You should strip the "pigtail" power
cable which came with your kit. You should have
one "pigtail" for each camera.

and the DVR end. It is very important that you identify these ends

before installing the cable so that you have the correct ends at the
correct location.

Step 2: Now take the red power cable lead and
twist it together with the black & white lead from
the power pigtail. Now take the black lead from
the power cable and twist it together with the all

provided with your system and twist them onto
the wires until they are firmly secured.