EZWatch 120-HD User Manual

DIGITAL VIDEO CAMERA

User's Manual

SKU# 120-HD

VANDAL PROOF and WEATHERPROOF

48 LED Units

ZOOM

FOCUS

• Suggested mounting height 8'-12'

WARNING

Effective Pixels PAL:752(H)x582(V) NTSC:768(H)x494(V)

Minimum illumination 0Lux(IR LED ON)

the camera; please seek help from a qualified professional for repair.

Electronic shutter Auto:1/50(1/60)-1/100,000Sec

S/N ratio >52dB

Lens 3-9mm

Ω

IR wave length 850nm

Power supply DV 12V±10%

• Avoid installation in unstable places

Power consumption less than 3.0W

• Do not mount camera directly to a metal surface

• Do not point camera directly into light sources

Image Sensor 1/3" SONY CCD

Attention:

To reduce the danger of electric shock, please do not open the case (or back
cover) of camera; everything needed for user operation is on the surface of

Signal system PAL/NTSC
Horizontal resolution 580TVL

Attention items:

• Do not touch CCD or lens

Video output 1.0Vp-p, 75

• Do not use any unidentified power supply

• Do not use camera in the following conditions,

IR distance 30-40M

Temperature: -20⁰C/+50⁰C

Making a BNC Connection

Connecting a Pre-made Cable

Step 1: Strip away all of the cable and shielding so

Connect this end to

Step 2: Then strip away the black outer jacket so

you have 1/4" of the shielding exposed. Do not

you have 1/4" of the shielding exposed. Do not

and the DVR end.

It is very important that you identify these ends

find the hole for the center conductor before you

Installing a power wire pigtail

Contact

EZWATCHPRO

www.ezwatch-security-cameras.com

Phone/Fax

power wire pigtail which connects to the camera

Technical Support/Sales

Toll Free 1-866-241-3400

International 001-801-4783980

Fax [phone]

Mail

Main Office/Mailing Address

Automated Video Systems

1600 S. State Street

provided with your system and twist them onto

you have 1/2" of the center conductor exposed as
shown in the picture.

allow any of the copper shielding to touch the
center conductor.

Step 3: Insert the cable into the fitting and gently
find the hole for the center conductor before you
press the fitting onto the wire. Now just twist the
fitting onto the wire while firmly pressing down
until the fitting is firmly on the cable.

Step 1: At the camera location, take the power
cable and strip away the outer sheathing to
expose the inner two wires (black & red). Then
strip away about 1/4" of the wires jacket to
expose the copper wire. Do the same to the

power connection as shown. Note: Do not strip or
cut the power lead coming directly from the
camera. You should strip the "pigtail" power
cable which came with your kit. You should have
one "pigtail" for each camera.

the camera.

The cables are labeled with a yellow wrap detailing the camera end

before installing the cable so that you have the correct ends at the
correct location.

Step 2: Now take the red power cable lead and
twist it together with the black & white lead from
the power pigtail. Now take the black lead from
the power cable and twist it together with the all
black lead from the pigtail. Use the gray wire nuts

the wires until they are firmly secured.

Salt Lake City, UT 84115