
Specifications — MTPX Plus Series
Video
Routing
MTPX Plus 816................... 8 x 16 matrix, 3 x 1 local
MTPX Plus 168................... 16 x 8 matrix, 3 x 1 local
MTPX Plus 1616................. 16 x 16 matrix, 3 x 1 local
MTPX Plus 1632................. 16 x 32 matrix, 6 x 2 local
MTPX Plus 3216................. 32 x 16 matrix, 6 x 2 local
MTPX Plus 3232................. 32 x 32 matrix, 6 x 2 local
Gain ................................................. Unity
Crosstalk
816, 168, 1616 models ........ -80 dB @ 1 MHz, -71 dB @ 5 MHz, -55 dB @ 10 MHz, -45 dB @ 30 MHz,
-37 dB @ 100 MHz
1632, 3216, 3232 models .... -90 dB @ 1 MHz, -76 @ 5 MHz, -72 dB @ 10 MHz, -60 dB @ 30 MHz,
-50 dB @ 100 MHz
Switching speed ............................ 200 ms (max.)
Video input— local
Number/signal type ..................... 3 or 6 analog RGBHV, RGBS, RGsB, RsGsBs, component video (bi-level and
tri-level), S-video, composite video
Connectors ..................................... 3 or 6 female 15-pin HD
Nominal level ................................ 0.7 Vp-p for RGB
Minimum/maximum levels ........ 0.3 V to 1.45 Vp-p with no offset at unity gain
Impedance ...................................... 75 ohms
Horizontal frequency .................... 15 kHz to 130 kHz
Vertical frequency .......................... 30 Hz to 150 Hz
Return loss ...................................... <-30 dB @ 5 MHz
DC offset (max. allowable)........... 250 mV
Video input — main (see transmitters' output specifications)
Number/signal type ..................... 8, 16, or 32 proprietary analog signals
Connectors ..................................... 8, 16, or 32 (depending on configuration) female RJ-45 connectors
Video output— local
Number/signal type ..................... 1 or 2 analog RGBHV, RGBS, RGsB, RsGsBs, component video (bi-level and
tri-level sync),
S-video, composite video
Connectors ..................................... 1 or 2 female 15-pin HD
Nominal level ................................ 0.7 Vp-p for RGB
Impedance ...................................... 75 ohms
Return loss ...................................... <-30 dB @ 5 MHz
DC offset ......................................... <±20 mV with input at 0 offset
Video output — main (see receivers' input specifications)
Number/signal type ..................... 8, 16, or 32 proprietary analog signals
Connectors ..................................... 8, 16, or 32 (depending on configuration) female RJ-45 connectors
Sync— local inputs and outputs only
Input type ....................................... RGBHV, RGBS, RGsB, RsGsBs
Output type .................................... See receiver specifications (see specifications on Web site).
Input level ...................................... 3.5 V to 5.5 Vp-p, unterminated; 4.0 V to 5.0 Vp-p normal
Output level ................................... See receiver specifications (see specifications on Web site).
Input impedance ........................... 573 ohms ± 5%
Output impedance ........................ 110 ohms
Extron MTPX Plus Series Twisted Pair Matrix Switchers • Specications
1

Specifications — MTPX Plus Series, cont’d
Max. input voltage ........................ 5.0 Vp-p
Max. propagation delay ............... 60 ns total
Max. rise/fall time ........................ 4 ns
Polarity............................................ Positive or negative
Audio
Routing
MTPX Plus 816................... 8 x 16 mono matrix, 3 x 4 local
MTPX Plus 168................... 16 x 8 mono matrix, 3 x 4 local
MTPX Plus 1616................. 16 x 16 mono matrix, 3 x 4 local
MTPX Plus 1632................. 16 x 32 mono matrix, 6 x 8 local
MTPX Plus 3216................. 32 x 16 mono matrix, 6 x 8 local
MTPX Plus 3232................. 32 x 32 mono matrix, 6 x 8 local
Gain (local inputs and outputs) .. Unbalanced output: 0 dB; balanced output: +6 dB
Frequency response ...................... 20 Hz to 20 kHz, ±1 dB
THD + Noise .................................. 0.15% @ 1 kHz at nominal level
S/N .................................................. >70 dB at maximum output (unweighted)
CMRR .............................................. >43 dB @ 20 Hz to 20 kHz
Audio input— local
Number/signal type ..................... 3 or 6 stereo, balanced/unbalanced
Connectors ..................................... (3) or (6) 3.5 mm captive screw connectors, 5 pole
Impedance ...................................... >10k ohms unbalanced
Nominal level ................................ +4 dBu (1.23 Vrms), -10 dBV (316 mVrms)
Maximum level .............................. +18 dBu, (unbalanced) at 1% THD+N
N
Audio input — main (see transmitters' output specifications)
Number/signal type ..................... 8, 16, or 32 proprietary analog signals
Connectors ..................................... 8, 16, or 32 (depending on configuration) female RJ-45 connectors
Audio output— local
Number/signal type ..................... 4 or 8 dual mono, balanced/unbalanced
Connectors ..................................... (4) or (8) 3.5 mm captive screw connectors, 5 pole
Impedance ...................................... 50 ohms unbalanced, 100 ohms balanced
Gain error ....................................... ±1 dB channel to channel
Maximum level (Hi-Z) ................. +18 dBu, balanced or unbalanced at 1% THD+N
Maximum level (600 ohm) ........... +15 dBm, balanced or unbalanced at 1% THD+N
Audio output — main (see receivers' input specifications)
Number/signal type ..................... 8, 16, or 32 proprietary analog signals
Connectors ..................................... 8, 16, or 32 (depending on configuration) female RJ-45 connectors
Control/remote — switcher host control
Serial host control ports ............... 1 RS-232 or RS-422, rear panel 9-pin female D connector
Baud rate and protocol ................. 9600 baud (default), 19200, 38400, and 115200 (adjustable); 8 data bits; 1 stop
Serial control pin configurations
Ethernet control port..................... 1 RJ-45 female connector
0 dBu = 0.775 Vrms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu
1 RS-232 front panel 2.5 mm mini stereo jack
bit; no parity
9-pin female D connector . RS-232: 2 = TX, 3 = RX, 5 = GND
RS-422: 2 = TX-, 3 = RX-, 5 = GND, 7 = RX+, 8 = TX+
Mini stereo jack .................. Tip = TX, ring = RX, sleeve = GND
2
Extron MTPX Plus Series Twisted Pair Matrix Switchers • Specications

Ethernet data rate .......................... 10/100Base-T, half/full duplex with autodetect
Ethernet protocol ........................... ARP, DHCP, ICMP (ping), TCP/IP, UDP, Telnet, HTTP, SMTP
Default settings .............................. Link speed and duplex level = autodetected
IP address = 192.168.254.254, Subnet mask = 255.255.0.0, Gateway = 0.0.0.0,
DHCP = off
Web server ...................................... Up to 200 simultaneous sessions
16 MB nonvolatile user memory
Program control ............................. Extron's control/configuration program for Windows®
Extron's Simple Instruction Set (SIS™)
Microsoft® Internet Explorer version 6 or higher, Telnet
Control/remote — external device (pass-through, unidirectional, or bidirectional)
Serial control ports ........................ RS-232, 3.5 mm captive screw connectors, 3 pole
3232 and 1632 models ....... 16 connectors
3216, 1616, and 816 models
8 connectors
168 models .......................... 4 connectors
Baud rate and protocol ................. Up to 38400 baud, 9600 baud (default); 5-8 data bits; 1 or 2 stop bits; odd,
even, or no parity;
XON, XOFF, or no flow control
N
Serial control pin configurations . 1 = TX, 2 = RX, 3 = GND
General
Recommended cable type ............ CAT 5/5E/6/7 (shielded or unshielded)
Power .............................................. 100 VAC to 240 VAC, 50/60 Hz, internal
Temperature/humidity ................ Storage: -40 to +158 °F (-40 to +70 °C) / 10% to 90%, noncondensing
Cooling ........................................... Fan, left to right (as viewed from the front panel)
Rack mount .................................... Yes
Enclosure type ............................... Metal
Enclosure dimensions
Product weight
Shipping weight
DIM weight (International)
Vibration ......................................... ISTA 1A in carton (International Safe Transit Association)
Protocol is mirrored between the switcher and the receiver.
1632, 3216, 3232 models .... 220 watts
816, 168, 1616 models ........ 120 watts
Operating: +32 to +122 °F (0 to +50 °C) / 10% to 90%, noncondensing
1632, 3216, 3232 models .... 5.25" H x 17.0" W x 9.4" D (3U high, full rack wide)
(13.3 cm H x 43.1 cm W x 23.9 cm D)
(Depth excludes connectors. Width excludes rack ears.)
816, 168, 1616 models ........ 3.5" H x 17.0" W x 9.4" D (2U high, full rack wide)
8.9 cm H x 43.1 cm W x 23.9 cm D
(Depth excludes connectors. Width excludes rack ears.)
1632, 3216, 3232 models .... 16 lbs (7.3 kg)
816, 168, 1616 models ........ 8.5 lbs (3.9 kg)
1632, 3216, 3232 models .... 26 lbs (ll.8 kg)
816, 168, 1616 models ........ 18 lbs (9 kg)
1632, 3216, 3232 models .... 26 lbs (11.8 kg)
816, 168, 1616 models ........ 18 lbs (9 kg)
Extron MTPX Plus Series Twisted Pair Matrix Switchers • Specications
3

Specifications — MTPX Plus Series, cont’d
Regulatory compliance
Safety ................................... CE, C-tick, CUL, UL
EMI/EMC .......................... CE, C-tick, FCC Class A, ICES, VCCI
Environmental ................... Complies with the appropriate requirements of WEEE.
MTBF ............................................... 30,000 hours
Warranty ......................................... 3 years parts and labor
N
N
All nominal levels are at ±10%.
Specifications are subject to change without notice.
7.6-100208-D11
4
Extron MTPX Plus Series Twisted Pair Matrix Switchers • Specications