
FEATURESDESCRIPTION
The Extr
on
MLS 304MA and MLS 304SA MediaLink™Switchers ar
e
simple-to-use, four input, multi-format active switchers with audio
amplifiers. Designed as economical solutions for single-projector
classrooms and conference rooms, both models provide composite
video, computer
-video, and audio switching.
The MLS 304MA and MLS 304SA include two inputs for composite
video with ster
eo audio on RCA connectors and two inputs for
computer-video with stereo audio on 15-pin HD connectors and
3.5 mm ster
eo mini jacks. Inputs three and four, both on 15-pin HD
connectors, are also configurable for computer-video, as well as
composite video. The switchers are equipped with dual RGB outputs.
One is on five BNC connectors and the other is on a 15-pin HD
connector. The 15-pin HD connector can also be utilized as a
buffered loop-through of input number 4 for a local monitor,
eliminating the need for a distribution amplifier and simplifying
operations.
MediaLink Switchers are designed to be used in conjunction with a
MediaLink Controller to facilitate low-cost integration. They can also
be used as stand-alone switchers.
Audio
For audio, each switcher includes two line level outputs (one fixed
and one variable) that can be configured for mono or stereo output
via RS-232. The MLS 304MA provides a 20 watt (rms) amplified
mono audio output on screw terminal for a 4 or 8 ohm load or
70/100 volt distributed audio system.
The MLS 304SA provides 24 watts (2 x 12 watts rms) for 4 ohm
speakers and 16 watts (2 x 8 watts rms) for 8 ohm speakers. Like the
line level outputs, the integrated audio amplifier can be configured
for stereo (default) or dual mono output via RS-232.
■ High
bandwidth –
280 MHz (-3 dB) RGB video bandwidth
maintains signal integrity.
■ Flexible video and ster
eo audio inputs –
Inputs one and two
accept composite video and stereo audio, and are on RCA
connectors. Inputs three and four accept computer-video or
composite video and stereo audio, and are on female 15-pin HD
and 3.5 mm ster
eo mini jacks.
■ Versatile video outputs – The MLS 304MA and MLS 304SA
include dual RGB outputs. One is on five BNC connectors and the
second is on a female 15-pin HD connector. The 15-pin HD can
also be utilized as a buffered local monitor loop-through for the
signal connected to input four.
■ Balanced audio – Balanced or unbalanced audio is output on
captive screw connectors. The two line level outputs (one fixed
and one variable) can be set for mono or stereo.
■ Integrated audio amplifier – The MLS 304MA provides 20 watt
(rms) amplified mono audio output on captive screw terminals for
a 4 or 8 ohm load or 70/100 volt distributed audio system. The
MLS 304SA provides 24 watts (2 x 12 watts rms) for 4 ohm
speakers and 16 watts (2 x 8 watts rms) for 8 ohm speakers.
■ Auxiliary/Mix audio – An additional input accepts mono line
level audio signals for mixing with any of the four switchable
inputs.
■ Volume control – Adjustable locally from the front panel or
remotely when integrated with a MediaLink Controller or a third
party RS-232 based control system.
MLS 304MA
MediaLink Switcher with
integrated mono amplifier
The MLS 304 switchers can
be used as a stand-alone
switcher, or combined with
the MediaLink family
Controller to create an
affordable system
integration solution.
MLC 206
MediaLink Controller
■ Loudness control – A unique audio feature of the MLS 304MA
and MLS 304SA that compensates for the nor
mal decr
eased
hearing ability of the human ear at low volume levels by
automatically boosting the low and high frequencies.
■ Triple-Action Switching™(RGB delay) – Blanks the screen
during switching of RGB signals to eliminate visible switching
transitions.
ont panel security lockout –
■ Fr
Allows security lockout of fr
ont
panel buttons and/or volume adjustment.
■ Remote control – The MLS Series Switchers are designed to work
with a MediaLink Controller. They can also be controlled via the
front panel or any third-party RS-232 based control system.
■ Rack-mountable – The MLS 304MA and MLS 304SA are housed
in a 1U, full rack width metal enclosure.
■ Inter
nal inter
national power supply

SPECIFICATIONS
VIDEO
Gain...................................................... Unity
Bandwidth
Differential phase error.......................... 1.0º at 3.58 MHz and 4.43 MHz
Differential gain error............................ 1.0% at 3.58 MHz and 4.43 MHz
Crosstalk .............................................. -68 dB @ 10 MHz, -39 dB @ 100MHz
Switching speed.................................... 5 ms (max.)
............................................ 280 MHz (-3 dB)
VIDEO INPUT AND LOOP-THROUGH
Number/signal/connectors.................... 2 RGBHV, RGBS, RGsB, RsGsBs on 15HD
Nominal level
Impedance............................................ 75 ohms
Horizontal frequency ............................ 15 kHz to 145 kHz
Vertical frequency.................................. 30 Hz to 170 Hz
Return loss
........................................ 1 V p-p for composite 0.7 V p-p for RGB
RGB.................................................. <-40 dB @ 5 MHz
Composite video.............................. <-40 dB, 0 to 10 MHz
1 RGBHV, RGBS, RGsB, RsGsBs local monitor
loop-through on 15HD
2 composite video on RCA
VIDEO OUTPUT
Number/signal/connectors.................... 1 RGBHV, RGBS, RGsB, RsGsBs on BNCs
Nominal level........................................ 1 V p-p for composite video, 0.7 V p-p for RGB
Impedance............................................ 75 ohms
Return loss ............................................ <-40 dB @ 5 MHz
Switching type...................................... Triple-Action (RGB delay)
1 composite video on BNC
SYNC
Input/output type ................................ RGBHV, RGBS, RGsB, RsGsBs (follows input)
Standards.............................................. TTL (RGB), NTSC 3.58, NTSC 4.43, PAL, SECAM
Input level ............................................ 0.5 V to 5.0 V p-p
Output level.......................................... TTL: 5.0 V p-p, unterminated
Input impedance .................................. 510 ohms
Output impedance................................ 75 ohms
Max input voltage ................................ 5.0 V p-p
Max. propagation delay........................ 30 ns
Max. rise/fall time ................................ 4.0 ns
Polarity.................................................. Positive or negative (follows input)
AUDIO
......................................................
Gain
Fr
THD + Noise
S/N at maximum power output (unweighted)
Crosstalk .............................................. <-80 dB @ 1 kHz, fully loaded
Stereo channel separation .................... >80 dB @ 1 kHz
CMRR.................................................... >75 dB @ 20 Hz to 20 kHz
esponse
equency r
Preamp/Lineout .............................. 20 Hz to 20 kHz, +0 dB/-0.15 dB
Direct (4/8 ohm).............................. 20 Hz to 20 kHz, +0 dB/-0.5 dB @ 1 W
Transformer (70V mono amplifier)...... 50 Hz to 20 kHz, +0 dB/-0.3 dB @ 1 W
Transformer (100V mono amplifier) .... 50 Hz to 20 kHz, +0 dB/-3 dB @ 1 W
Power amp (mono or stereo)
8 watts/8 ohms ........................ <0.05% @ 1 kHz, 20 kHz bandwidth
12 watts/4 ohms ...................... <0.25% @ 1 kHz, 20 kHz bandwidth
Preamp/Lineout .............................. <0.07% @ 1 kHz, 20 kHz bandwidth
Power amp ...................................... >80 dB @ 10 Hz to 22 kHz
Preamp/Lineout .............................. >90 dB @ 10 Hz to 22 kHz
Unbal. output: 0dB; bal. output: +6dB
AUDIO INPUT
Number/signal/connectors.................... 2 stereo, unbal. line level on RCA (input 1-2)
Impedance............................................ >10 kohms unbal., DC coupled
Nominal level........................................ -10 dBV (316 mVrms)
Maximum level .................................... +8 dBV (2.51 Vrms), unbal. at <0.1%THD+N
2 stereo, unbal. line level on 3.5 mm TRS
(input 3-4)
1 mono, bal./unbal. line level on 3.5 mm captive
screw (aux/mix input)
+10 dBu (2.45 Vrms), bal. at <0.1% THD+N
Input gain adjustment .......................... -42 dB to +24 dB, adjustable per input
NOTE: 0 dBu = 0.775 V
rms, 0 dBV = 1 Vrms, 0 dBV ≈ 2 dBu
AUDIO OUTPUT — LINEOUT AND PREAMP
Number/signal/connectors.................... 1 stereo/mono, bal./unbal. line level on 3.5 mm
Impedance............................................ 50 ohms unbal., 100 ohms bal.
Nominal level........................................ Configurable: -10 dBV (316 mVrms, default), +4
Power amp (mono or stereo) .......... >+17 dBu, bal. <0.5% THD+N
Preamp ............................................ >+19 dBu, bal. <0.1% THD+N
Lineout ............................................ >+16 dBu, bal. <0.1% THD+N
NOTE: Unbal. wired outputs produce 6 dB of attenuation. Bal. outputs have unity
gain/attenuation.
AUDIO OUTPUT —
Number/signal/connector .................... 1 mono on 5-position screw terminal
Sensitivity @ max power ...................... -20 dBV (100 mVrms) (adjustable)
Power bandwidth
Direct (4 ohm)................................ 20 Hz to 20 kHz, 0.5% THD
Direct (8 ohm)................................ 20 Hz to 20 kHz, 0.15% THD
Transformer (70V) .......................... 50 Hz to 20 kHz, 1% THD
Transformer (100V) ........................ 50 Hz to 20 kHz, 0.5% THD
Maximum power output
Direct (4/8 ohm) ............................ 20 watts max. (rms)
Transformer (70/100V) .................. 16 watts max. (rms), transformer coupled
Protection ............................................ Input limiting, thermal, short circuit
AUDIO OUTPUT —
Number/signal type .............................. 1 stereo (default) or dual mono (configured via
Sensitivity @ max. power ...................... -20 dBV (adjustable)
Power bandwidth at maximum power output
Direct (4 ohm)................................ 10 Hz to 20 kHz, 0.5% THD
Direct (8 ohm)................................ 20 Hz to 20 kHz, 0.8% THD
Maximum power output
Direct (4 ohm)................................ 24 watts max., (12 watts rms per channel)
Direct (8 ohm)................................ 16 watts max., (8 watts rms per channel)
Protection.............................................. Input limiting, thermal, short circuit
captive screw (lineout)
1 stereo/mono, bal./unbal. variable level on
3.5 mm captive scr
dBu (1.23 Vrms) Maximum level (600 ohm)
MONO POWER AMP (MLS 304MA, ONLY)
STEREO POWER AMP (MLS 304SA, ONLY)
software) on 5-position screw terminal
ew (preamp)
CONTROL/REMOTE — SWITCHER
t.................................. RS-232, 3.5 mm captive screw connector, 5 pole
Serial contr
Baud rate and pr
Pr
ol por
ogram contr
ol
(uses 3 poles)
..........................
otocol
....................................
9600, 8-bit, 1 stop bit, no parity
Extr
Extr
on’s configuration program for Windows
s Simple Instr
on’
uction Set (SIS)
™
®
GENERAL
....................................................
Power
Rack mount
Metal Enclosur
Pr
Shipping weight
Listings
Compliances
NOTE: All nominal levels ar
Model
MLS 304MA
MLS 304SA
..........................................
e dimensions
oduct weight
......................................
....................................
..................................................
..........................................
..........................................
............................................
..................
±
e at
AC to 240 V
100 V
nal, autoswitchable
inter
es, with included brackets (#70-077-03)
Y
1.75" H x 17.5" W x 8.5" D 4.4 cm H x
44.4 cm W x 21.6 cm D
6.0 lbs (2.7 kg)
11 lbs (5 kg)
UL, CUL
CE, FCC Class A, VCCI, AS/NZS, ICES
10%.
t Numbers
Par
60-550-01
60-550-02
AC, 50/60 Hz, 60 watts,
Specifications ar
e subject to change without notice.