Page 1
Excalibur Electronics
Userʼs Guide for
ASCAR
®
RC
Model No.: 9507-3/9507-29/9507-99
www.ExcaliburElectronics.com
For Ages 7 and Up
Page 2
Installing Bat
terie
s
To install batteries in the transmitter, please
follow the steps below:
2. Insert one 9-volt battery making sure to match the
polarity (+ and -) as shown in the battery
compartment.
3. Replace battery cover.
To install the batteries, please follow the steps
below:
2. Install 3 - AA batteries into the compartment making sure to match the
polarity (+ and -) as indicated inside the compartment
3. Close and secure the battery compartment.
C
ongratulations on your purchase of the 1:20 NASCAR
®
RC from
Excalibur Electronics, Inc. You and your friends will enjoy hours of fun
driving your 1:20
NASCAR
®
RC.
Your 1:20
NASCAR
®
RC is easy to use but be sure to use it safely. Read
this manual thoroughly before playing. Take note of safety, care and battery
information. Keep this manual for reference.
This package contains 1 - 1:20
NASCAR
®
RC, 1 Transmitter, 1 Tube for
vehicle antenna, 1 Transmitter Antenna, and 1 Userʼs Guide.
NASCAR® is a registered trademark of The National Association for Stock
trademarks of Offi ce Depot.
Table of Contents
Installing Batteries. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 2
Controls. . . . . . . . . . . . . . .. . . . . . . . . . . . . . . . . . . . . . . . page 3
Operating Your RC Car. . . . . . . . . . . . . . . . . . . . . . . . . . . page 3
Troubleshooting. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 4
Battery Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . page 5
90-Day Limited Warranty. . . . . . . . . . . . . . . . . . . . . . . . . page 6
Page 3
Controls
Left Stick:
Push up to drive the vehicle forward.
Push down to drive the vehicle in reverse.
Right Stick:
Push left to steer the vehicle left. Push
right to steer the vehicle right.
Trim Switch Control:
The trim switch is located on the
underside of your vehicle. This is used
to align the wheels for consistent straight
line driving. Switch left or right to align
the wheels.
On/Off: Switch to turn the transmitter on
or off.
Operating Your RC Car
through the hollow tube. Avoid pulling
the wire too tight. The wire is on the
top of your 1:20
NASCAR
®
RC.
Tie a knot on top to secure.
2. Turn the switch to the ON position for
power.
3. In a clockwise direction, screw the
antenna into the cavity located at the
top of the transmitter.
4. Use the control switches on the
transmitter to drive your 1:20
NASCAR
®
RC. The switches
allow you to drive it forward, back, left
and right.
You can control your 1:20
NASCAR
®
RCʼs turns with the control sticks.
Maneuver both control sticks to turn your
NASCAR
®
RC in any direction you
would like.
Troubleshooting
If your 1:20
NASCAR
®
RC doesnʼt
move, please check the following
potential causes:
• The power switch is turned off. If
that is the case, turn the power
switch on.
• Your 1:20
NASCAR
®
RC is too far
away from the controller. If that
is the case, bring your 1:20
NASCAR
®
RC closer to the
controller.
• The metal tab in the battery
compartment is fl attened and not
touching the batteries installed. If
that is the case, lift up the metal tab
so it touches the tip of the battery.
If you lose control of your 1:20
NASCAR
®
RC, please check the
following potential cause:
• Another radio controlled vehicle
using the same frequency is
operating near your vehicle, or a
CB is being operated nearby.
If that is the case, you should race
other vehicles that use different
frequencies or channels, or move
away from your location until there
is no more interference.
If your 1:20
NASCAR
®
RC drives
power, please check the following
potential causes:
• There are weak batteries in the
transmitter. If that is the
case, replace with new batteries.
• There is strong interference in the
surrounding area. If that is the
case, you should move to a better
location to drive your 1:20
NASCAR
®
RC.
Safety and Care
• Check the wheel mechanisms
for lint, thread, hair or dust
frequently. This ensures the wheels
move freely and that the motor is
not stressed.
• Avoid rough handling such as
bumping or dropping.
• Avoid moisture and extreme
temperatures. For best results, use
between the temperatures of 39º F
and 100º F (4º C and 38º C).
• Never drive your 1:20
NASCAR
®
RC
on a wet fl oor, on sand, or in mud,
rain or snow. These can damage it.
• Be sure to remove the batteries
from your 1:20
NASCAR
®
RC and
transmitter when storing the
product.
• To protect your 1:20
NASCAR
®
RCʼs
wheel mechanism from lint, thread,
hair and dust particle, you can use
a small brush, tweezers or tie a
small bit of cloth to the tip of a
toothpick, etc., and wipe it off.
• Always keep your 1:20
NASCAR
®
RC clean. Use a dampened cloth
3
Antenna Tube Holder
Antenna Wire
Antenna Tube
Left/Right
Forward
Reverse
Left Turn
Right Turn
Reverse
Left
Reverse
Right
Reverse
Forward
Page 4
to wipe off, and then wipe all the
water off with a dry cloth. Never
use chemicals to clean your 1:20
NASCAR
®
RC.
• Avoid holding the wheels when
rotating. Holding them will
cause the electronic components
to short-circuit, overheat and cause
malfunction.
Battery Information
• Use alkaline batteries for best
performance.
• Use 3 AA batteries for your 1:20
NASCAR
®
RC.
• Use one 9-volt battery for your
transmitter.
• Do not use rechargeable batteries.
• Remove exhausted batteries from
the unit.
• Do not short circuit battery
terminals.
• To avoid explosion or leakage,
do not dispose of batteries in a fi re
or attempt to recharge standard or
alkaline batteries.
• Be sure to insert batteries with the
correct polarities and always
follow the toy and battery
manufacturersʼ instructions.
• Remove batteries and store them in
a cool, dry place when not in use.
• Always remove old and dead
batteries from the product.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium)
batteries.
Rules. Operation is subject to the following
two conditions: (1) this device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
NOTE: This equipment has been tested and
found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation.
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment into an outlet
on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
90-Day Limited Warranty
EXCALIBUR ELECTRONICS, INC.,
warrants to the original consumer that its
products are free from any electrical or
mechanical defects for a period of 90 DAYS
from the date of purchase. If any such defect
is discovered within the warranty period,
EXCALIBUR ELECTRONICS, INC., will
repair or replace the unit free of charge upon
receipt of the unit, shipped postage prepaid and
insured to the factory address show at right.
The warranty covers normal consumer
use and does not cover damage that occurs
in shipment or failure that results from
alterations, accident, misuse, neglect, wear
and tear, inadequate maintenance, commercial
use, or unreasonable use of the unit. Removal
of the top panel voids all warranties. This
warranty does not cover cost of repairs made or
attempted outside of the factory.
Any applicable implied warranties,
including warranties of merchantability
and fi tness, are hereby limited to 90 DAYS
from the date of purchase. Consequential or
incidental damages resulting from a breach of
any applicable express or implied warranties
are hereby excluded. Some states do not
allow limitations on the duration of implied
warranties and do not allow exclusion of
incidental or consequential damages, so the
above limitations and exclusions in these
instances may not apply.
The only authorized service center in the
United States is:
Excalibur Electronics, Inc.
Miami, FL 33186 U.S.A.
Phone: (305) 477-8080
Fax: (305) 477-9516
www.ExcaliburElectronics.com
Ship the unit carefully packed, preferably
in the original carton, and send it prepaid, and
adequately insured. Include a letter, detailing
the complaint and including your daytime
telephone number, inside the shipping carton.
If your warranty had expired and you want an
estimated fee for service, write to the above
address, specifying the model and the problem.
PLEASE DO NOT SEND YOUR UNIT
WITHOUT RECEIVING AN ESTIMATE
FOR SERVICING.
WE CANNOT STORE YOUR UNIT!
5
6
Page 5
Excalibur Electronics, Inc.
th
Avenue
Miami, Florida, 33186 USA
Phone: 305.477.8080
Fax: 305.477.951
Please Visit Us
At:
www.ExcaliburElectronics.com
9507-3/29/99 NASCARRC 052907 v2
Loading...