How it Works
ETS-Lindgren
Loading...
8000-055
User Manual
25 pgs479.12 Kb0

ETS-Lindgren 8000-003, 8000-055 User Manual

Model 8000-003
RF Power Amplifier
User Manual
ii
ETS-Lindgren Inc. reserves the right to make changes to any products herein to improve
Revision
Description
Date
A
Initial Release
September, 2014
functioning or design. Although the information in this document has been carefully reviewed and is believed to be reliable, ETS-Lindgren does not assume any liability arising out of the application or use of any product or circuit described herein; nor does it convey any license under its patent rights nor the rights of others. All trademarks are the property of their respective owners.
© Copyright 2014 by ETS-Lindgren Inc. All Rights Reserved. No part of this document may be copied by any means without written permission from ETS-Lindgren Inc.
Trademarks used in this document: The ETS-Lindgren logo is a registered trademark and Calibration Services Plus is a trademark of ETS-Lindgren Inc.
Revision Record
MANUAL,8000-003 | Part #399602, Rev. A
iii
Table of Contents
Notes, Cautions, and Warnings ......................................................................... v
Safety Symbols ................................................................................................ ... v
1.0 Introduction ................................ ................................ ................................ ... 7
Standard Configuration ....................................................................................................... 7
2.0 Maintenance ................................................................ ................................ .. 9
Service Procedures .......................................................................................................... 10
Contacting ETS-Lindgren ........................................................................................... 10
Sending a Component for Service ............................................................................. 10
3.0 Specifications .............................................................................................. 11
Electrical Specifications .................................................................................................... 11
Physical Specifications ..................................................................................................... 11
4.0 Before You Begin ........................................................................................ 13
Unpacking ......................................................................................................................... 13
Safety Information ............................................................................................................ 13
Warnings ........................................................................................................................... 14
5.0 Installation ................................................................................................... 15
Star / Delta Configuration ................................................................................................. 15
Mains Input ....................................................................................................................... 15
Amplifier Protection .......................................................................................................... 15
6.0 Operation ..................................................................................................... 17
Equipment Use ................................................................................................................. 17
Mains Switch..................................................................................................................... 17
Standby/Operate Switch (Centre Unit) ............................................................................. 17
Fault Indicator (Red LED) ................................................................................................. 18
Interlock Indicator (Orange LED) ...................................................................................... 18
Local Lockout Indicator ..................................................................................................... 18
RF Input (Depending on model) ....................................................................................... 18
RF Output (Depending on model) .................................................................................... 18
Air Inlet .............................................................................................................................. 19
Safety Interlock ................................................................................................................. 19
Fan Outlet ......................................................................................................................... 19
Appendix A: Warranty ...................................................................................... 21
Scope and Duration of Warranties ................................................................................... 21
iv
Warranty Exclusions ......................................................................................................... 22
Buyer’s Remedies ............................................................................................................ 22
Appendix B: EC Declaration of Conformity .................................................... 25
v
Note: Denotes helpful information intended to provide tips for better use of the product.
CAUTION: Denotes a hazard. Failure to follow instructions could result in minor personal injury and/or property damage. Included text gives proper procedures.
WARNING: Denotes a hazard. Failure to follow instructions could result in SEVERE personal injury and/or property damage. Included text gives proper procedures.
Warning: Avoid exceeding the stated maximum input level as this can cause a risk of damaging the equipment.
Warning: There is a significant risk of an electrical or burn hazard, to avoid this always ensure the output is terminated prior to switching on the equipment.
Protective Earth Ground (Safety Ground): Indicates protective earth terminal. You should provide uninterruptible safety earth ground from the main power source to the product input wiring terminals, power cord, or supplied power cord set.
Waste Electrical and Electronic Equipment (WEEE) Directive: (European Union) At end of useful life, this product should be deposited at an appropriate waste disposal facility for recycling and disposal. Do not dispose of with household waste.
Notes, Cautions, and Warnings
Safety Symbols
vi
This page intentionally left blank.
Introduction
7
1.0 Introduction
The ETS-Lindgren Model 8000-003 RF Power Amplifier is capable of supplying a minimum of 500 watts into a 50 ohm load over the frequency range 80MHz to 1000MHz. The amplifier is designed with sufficient gain so that it may be used with normal output levels of signal sources.
A safety interlock on the rear panel is also provided, which will mute the
The unit is powered by a switched mode power supply for high efficiency,
A front panel fault indicator is provided to indicate over-temperature, loss of
amplifier when grounded.
high power factor, and a wide voltage range operation. The unit is air cooled with integral fans and is protected against faulty cooling by excess temperature sensing.
air flow, or fan failure, and any potential imbalance between the 250W amplifier units.
The amplifier is designed for rugged operation into a variety of loads and is primarily intended for use as an RF power source for EMC susceptibility testing, but is also applicable to other systems requiring a wide-band linear amplifier.
This amplifier is designated as Professional Equipment and should not be operated by untrained staff. As this product has the capability to generate high levels of RF energy it is not intended for use in a residential environment.
Standard Configuration
The 8000-003 amplifier system comes already assembled and connected in a
19-inch 25U rack.
The N type input and 7/16 output connectors are located on the rear panel.
8
Introduction
This page intentionally left blank.
Loading...
+ 17 hidden pages
Buy Points How it Works FAQ Contact Us Questions and Suggestions Privacy Policy Cookie Policy Terms of Use