1. Protecting cap
2. Stainless steel cutting system
3. Cutting head
4. BIPIN-lamp
5. ON/OFF switch
6. Battery cover
Instructions for use for the washable nasal and ear hair
trimmer.
1. Protecting cap
2. Stainless steel cutting system
3. Cutting head.
4. BIPIN-lamp:
5. OWOFF switch
6. Battery cover
IMPORTANT SAFETY INSTRUCTIONS
When using a battery operated appliance, basic safety precautions
should always be followed, including the following. Read all
instructions before using the product.
When using a battery operated appliance, basic safety precautions
should always be followed, including the following. Read all
instructions before using the product.
SAFETY
You trimmer is an electrical device, please pay attention to the
following safety instructions:
•
Only use the trimmer as described in this manual
•
Ensure tight seat of the cutting head(3).
•
Not suitable for children and keep out of reach of children.
•
This is a washable product. It can be cleaned easily and safely
under running water. However.
•
Do not immerse the trimmer in water.
•
Check the trimmer for mechanical damaged. A damaged cutter
may result in injury.
•
The equipment meets the requirements of the EU guideline on
Electromagnetic Compatibility (EMC) 89/336/EEC.
Battery installation / replacement
Holding the trimmer upside down. Rotate the battery cover
counterclockwise until the cover unlocks from the unit.
Insert one AA alkaline battery compartment, positive side up.
Replace the battery cover and turn clockwise to snap into place.
To avoid pulling of hairs, replace battery when it begins to get weak.
! Do not dispose of used batteries with hose-hold rubbish.
Take used batteries to a convenient collection point.
Trimming operation
Remove the protecting cap by pulling it from the unit. Switch the
trimmer on.
Trimming nose hair
Make sure nasal passages are clean. Slowly
move the cutting head in and out, of each
nostril to remove unwanted hair.
Caution: Do not insert tip more the 0.5 cm into nostril. For
best results, make sure the side of the tip is firm against skin.
This will reduce the tickling effect that can occur.
Trimming ear hair
Clean outer area of ear and make sure it is
free of wax. Pull ear flat to head with one
hand and hold trimmer with the other. Turn
trimmer on and move tip around edges of
ear to remove hairs extending beyond the
outer ear. Then carefully insert tip into
outer ear no more than 0.5 cm.
Caution- To avoid injury do not put any part of trimmer into
inner ear. Do not insert the trimmer further than 0.5cm into
the ear as this could cause damage to the eardrum.
Trimming eyebrows
Turn trimmer on and use tip to cut straight
eyebrow hair. To shape and trim eyebrow,
hold trimmer at even distance form your
head and move across the eyebrow.
Cleaning of the trimmer
If necessary the trimmer may be cleaned
under running water. Turn the trimmer
“off“ and rinse the cutting head under warm
water.
For more though cleaning, remove cutting head assembly (unscrew in
clockwise direction) and rinse under running water to remove hairs
from inside of assembly.
After cleaning, return cutting head assembly to its original position
(turn counter-clockwise) and wipe entire trimmer dry with soft cloth.
Always replace protecting cap before storing the trimmer.
! IMPORTANT: DO NOT immerse or submerge Trimmer.
Loading...