Page 1
Page 2
Page 3
WARNING:
CADDY FASTENERS ARE INTENDED FOR INDOOR USE IN NON-
CORROSIVE ENVIRONMENTS ONLY. CADDY FASTENERS MUST BE USED
ONLY AS ILLUSTRATED. MISUSE OR MISAPPLICATION MAY CAUSE FAILURE
RESULTING IN PROPERTY DAMAGE OR BODILY INJURY.
NOTE: STATIC LOAD LIMITS ARE FOR FASTENER ONLY. STRUCTURES
TO WHICH THE FASTENER IS ATTACHED MUST BE EVALUATED
SEPARATELY.
IMPORTANT: WHEN USING CADDY FASTENERS:
1. WIRE AND ROD, MUST MEET A.I.S.I. CARBON OR STEEL
WIRE AND ROD STANDARDS-FOR COARSE ROUND WIRE.
2. FLANGES, PURLINS, ANGLE IRON, BAR JOISTS ETC., MUST MEET A.I.S.I. HOT
ROLLED AND COLD FINISHED BAR STANDARDS.
3. THREADED ROD, MUST MEET A.I.S.I. THREADED ROD SPECIFICATIONS
AND TOLERANCES.
SAFETY INSTRUCTIONS: ALL SAFETY REGULATIONS
REQUIRED BY THE JOBSITE MUST BE OBSERVED. SPECIAL
ATTENTION SHOULD BE GIVEN TO THE FOLLOWING INSTRUCTIONS:
WHILE WORKING OR ON THE JOBSITE:
1. OBSERVE ALL FEDERAL AND LOCAL
SAFETY REGULATIONS.
2. WEAR A HARD HAT.
3. WEAR SAFETY GLASSES WITH SIDE SHIELDS.
4. WEAR GLOVES TO AVOID SPLINTERS
AND CUTS.
5. WHEN WORKING ABOVE GROUND
LEVEL, BE SURE THE STRUCTURE WILL
SUPPORT YOUR WEIGHT.
6. BE AWARE OF PERSONNEL WORKING ABOVE AND BELOW.
Loading...