ERICO ROD LOCK Strut User Manual
INSTRUCTION SHEET
CADDY® ROD LOCK Strut
1/2" Threaded Rod, A12 & C14 Struts, 14" - 50" span
Note: Product must be installed with the open side of the channel facing up.
See Figure 1.
1/2 F
L1
L
FIGURE 1
1/2 F
See Sheet 2 for
Installation.
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
1.
www.erico.com
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
2.
All instructions must be
3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property
4.
damage, serious bodily injury and death.
Products that are manufactured using spring steel components shall be used only in a non-corrosive indoor environment.
5.
All pipe supports, hangers, intermediate components and structural attachments must ONLY be used as described herein and are NEVER to be used for any
6.
other purpose.
NOTE: All load ratings are for static conditions and do not account for dynamic loading such as wind, water or seismic loads, unless otherwise noted.
The customer is responsible for:
a. Conformance to all governing codes.
b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified
engineer.
c. Using appropriate industry standard hardware as noted above.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
and from your ERICO customer service representative.
completely
followed to ensure proper and safe installation and performance.
TECHNICAL SUPPORT:
www.erico.com
CFS511_A
1 OF 2
© 2014 ERICO International Corporation.
INSTRUCTION SHEET
CADDY® ROD LOCK Strut
1/2" Threaded Rod, A12 & C14 Struts, 14" - 50" span
1
As Shipped
Rotate counter clockwise
2
2 full turns to insert rod.
3
Push rod into
CADDY ROD LOCK
Top of rod must be
positioned at or above
top of locknut
4
Hand tighten
bottom locknut
Rotate hex shaped main
housing with 1-3/16" or
30mm open end wrench
to adjust height of
threaded rod.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
5
TECHNICAL SUPPORT:
www.erico.com
CFS511_A
2 OF 2
© 2014 ERICO International Corporation.
Loading...