ERICO Plumbing Pre-Fab Bracket User Manual
INSTRUCTION SHEET
Plumbing Pre-Fab Bracket
Adjustable Plastic Plumbing Support
Part
Number
PFB1624
PFBNB
PFBC
Tighten hose clamp
1
around central pipe.
Article
Number
403100
403104
403106
Max Torque: 30 in-lb [3.4Nm]
3
Place supply pipes
in appropriate locations
Description
Telescoping Plumbing Prefab Bracket
Plumbing Prefab Bracket
Plumbing Prefab Bracket Clamp
Fasten pipes to bracket
with clamps.
Max torque: 15 in-lb [1.7Nm]
4.00" [101mm]
15.75-25 [400-635]
2
Remove clamps
by pulling up
4
Stud Spacing
in [mm] in [mm]
-
- -
Central pipe
dia. range
1.9-4.5 [48-114]
1.9-4.5 [48-114]
Supply pipe dia.
CT & IP
1/2 - 3/4
1/2 - 3/4
1/2 - 3/4
DN
15-20
15-20
15-20
6.00" [152mm]
8.00" [203mm]
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
1.
www.erico.com
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
2.
All instructions must be
3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property
4.
damage, serious bodily injury and death.
Products that are manufactured using spring steel components shall be used only in a non-corrosive indoor environment.
5.
All pipe supports, hangers, intermediate components and structural attachments must ONLY be used as described herein and are NEVER to be used for any
6.
other purpose.
NOTE: All load ratings are for static conditions and do not account for dynamic loading such as wind, water or seismic loads, unless otherwise noted.
The customer is responsible for:
a. Conformance to all governing codes.
b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified
engineer.
c. Using appropriate industry standard hardware as noted above.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
TECHNICAL SUPPORT:
www.erico.com
and from your ERICO customer service representative.
completely
followed to ensure proper and safe installation and performance.
CFS492_B
1 OF 2
© 2014 ERICO International Corporation.
INSTRUCTION SHEET
5
Telescope bracket out to width
of studs and bend ends up
6
Attach fastner to side face of the
stud with a screw gun
Contractor tip:
Bend tab back 180
for added room
Bend ends up
7
Slide pipe assembly to desired
location and lock down with
pre-installed screws
Telescope out
Slide assembly side to side to locate
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
TECHNICAL SUPPORT:
www.erico.com
CFS492_B
2 OF 2
© 2014 ERICO International Corporation.
Loading...