ERICO LPAW70ISOT User Manual

INSTRUCTION SHEET

ISODC "Y" Splice

LPAW50ISOT & LPAW70ISOT

Installation Tools:

5/16" Hex

Installation Instructions:

Strip 60 mm [2.36 in] of insulation from the downconductor

1.
and 50 mm [1.97 in] of insulation from the end of the
branch connector.
Remove oxides from bare conductors and connector

2.
with wire brush. (Required for Aluminum; Recommended
for Copper)
Apply oxide inhibitor (Penetrox A-13 or equivalent) to

3.
conductors and connector. (Required for Aluminum;
Recommended for Copper)

4.

Apply threadlocker (Loctite

®

263TM or equivalent)* to both

screw and connector threads.
Tighten screw to installation torque.

5.

* Loctite® 271TM threadlocker can be used as a substitute for
Loctite® 263TM. Loctite® 7649TM activator needs to be applied
if using Loctite® 271TM.

Downconductor

Branch
Connector

60 mm

[2.36 in]

Downconductor

Installation Torque:

220 in-lb [25 N-m]

50 mm

[1.97 in]

Branch Connector

WARNING:

ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at

1.

www.erico.com

ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.

2.
All instructions must be

3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property

4.
damage, serious bodily injury and death.

SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.

Loctite is a registered trademark of Henkel Corporation

CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.

TECHNICAL SUPPORT

www.erico.com

and from your ERICO customer service representative.

completely

followed to ensure proper and safe installation and performance.

IP8216_A

1 OF 1

© 2013 ERICO International Corporation.