ERICO IP8274 User Manual

INSTRUCTION SHEET

ERICO® CADWELD®

Bus to Horizontal Steel, Tap Flat
Style CG

L160 Handle Clamp

CADWELD Mold

Tap hole

Center line of
mold / tap hole

Shim Piece of Strip / Conductor

Strip / Conductor

Steel surface

Prior to making a connection, read and follow the full instruction sheet (IPP & IPRNS)
shipped with CADWELD mold and special instructions below.

1. From existing conductor stock, cut a 2 inch piece to sandwich in the mold as shown
as a shim piece.

2. Material must be flat to keep from springing the mold.

3. The conductor ends should be centered under tap hole.

4. Lock mold halves with L160 Handle Clamp, making sure there are no gaps.Secure

mold to steel surface.

5. Follow standard welding instructions.

WARNING:

ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at

1.

www.erico.com

ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.

2.
All instructions must be

3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property

4.
damage, serious bodily injury and death.

SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.

CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.

TECHNICAL SUPPORT

www.erico.com

and from your ERICO customer service representative.

completely

followed to ensure proper and safe installation and performance.

IP8274_A

1 OF 1

© 2014 ERICO International Corporation.