ERICO IP7420 User Manual

INSTRUCTION SHEET

INSTRUCTION SHEET

Cable to Lug
Horizontal Tap
Perpendicular
to Flange

Position Hole in
Lug Over Screw

Mold Halves

.25" [6.4 mm] Gap

Mold Bottom

Remove First

Prior to making a connection, read and follow the full instruction sheet IPRF, the full
instruction sheet shipped with CADWELD (IPX), and special instructions below.

Clamp bottom of mold to rail using vise grips.

1.
Position hole in lug over hex head screw in bottom of mold (As shown above).

2.

®

This will gap lug .25" [6.4 mm] from rail.
Lock top sections of mold together using "E-Z" change handles.

3.
Position mold top on mold bottom.

4.
Lock top and bottom sections together using frame toggles.

5.
Pack all openings between mold and rail, which may leak molten metal with

6.
ERICO packing material.
After completion of weld and waiting period, unlatch toggle clamps and vise

7.
grips and remove mold bottom first (As shown above).
Open "E-Z" change handle clamp on top section of mold and remove mold.

8.

Note:

Care should be exercised when removing mold from rail to prevent chipping of

graphite parts.

WARNING:

ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at

1.

www.erico.com

ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.

2.
All instructions must be

3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property

4.
damage, serious bodily injury and death.

SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.

CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.

TECHNICAL SUPPORT:

TECHNICAL SUPPORT:

www.erico.com

www.erico.com

and from your ERICO customer service representative.

completely

followed to ensure proper and safe installation and performance.

IP7420_C

1 OF 1

1 OF 1

© 1995, 2012, 2013
ERICO International Corporation