ERICO IP7072 User Manual

INSTRUCTION SHEET

Cable to Lug
Horizontal Splice

Gap as Noted

Prior to making a connection, read and follow the full instruction sheet IPRNS, the
full instruction sheet IPP, the full instruction sheet shipped with CADWELD (IPX),

®

and special instructions below.

Place 2 cables and lug in bottom section of mold.1.

Place rope packing on top of cables in bottom section of mold. Place 2.
remaining cable on top of bottom cables and rope packing.

Gap cables and lug directly under center of tap hole (As noted on mold tag).3.

Lock top sections of mold together. Then lock top and bottom sections 4.
together.

Fill all remaining openings with CADWELD mold sealer.5.

WARNING:

1. ERICO products shall be installed and used onl y as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
www.erico.com and from your ERICO customer service representative.

2. ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manne r that exceeds specified load ratings.

3. All instructions must be completely followed to ensure proper and safe installation and performance.

4. Improper installation, misuse, misapplication or other failure to completely foll ow ERICO's instructions and warnings may cause product malfunction, property
damage, serious bodily injury and death.

SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.

CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.

TECHNICAL SUPPORT:

www.erico.com

IP7072_D

1 OF 1

© 1995, 2012, 2013
ERICO International Corporation