ERICO IP6674 User Manual
INSTRUCTION SHEET
INSTRUCTION SHEET
Horizontal Splice,
Single to Multiple Cable
Prior to making a connection, read and follow the full instruction sheet IPRNS, IPP, and
the full instruction sheet shipped with CADWELD® (IPX) and special instructions below.
Position mold on cables with cables butted under center of tap hole.
1.
If using sleeve let cable protrude .063" [1.6 mm] beyond end of sleeve.
2.
Use CADWELD mold sealer (ERICO part number T403) between cables to help
3.
prevent leakage.
WARNING:
ERICO products shall be installed and used only as indicated in ERICO product instruction sheets and training materials. Instruction sheets are available at
1.
www.erico.com
ERICO products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings.
2.
All instructions must be
3.
Improper installation, misuse, misapplication or other failure to completely follow ERICO's instructions and warnings may cause product malfunction, property
4.
damage, serious bodily injury and death.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH, and LENTON are registered trademarks of ERICO International Corporation.
TECHNICAL SUPPORT:
TECHNICAL SUPPORT:
www.erico.com
www.erico.com
and from your ERICO customer service representative.
completely
followed to ensure proper and safe installation and performance.
IP6674_C
IP6674_C
1 OF 1
1 OF 1
© 1995, 2012, 2013
ERICO International Corporation
Loading...