Erbessd Reliability EI-BALANCE Specifications

Datasheet

A complete and
useful Dynamic

2-Plane
Balancing
System

EI-BALANCE

SINGLE AND TWO PLANE BALANCING SOFTWARE

Only for illustrative purposes. Tablet is not included.

Overview

E

I-Balance is a balancing tool for single and two plane balancing installable on any

Windows laptop or tablet; this equipment is specially designed for field balancing using
the influence coefficient method (does not include the balancing wizard found in the
DigivibeMX M10 & M30.

Thanks to its automated tracking filter, the system identifies the RPM in a selected
range to avoid inaccuracies in case of slight changes in speed.

B

alancing speed range from 100 to 120,000 RPM with signal recording time up to 1

minute.

Th

e EI-Balance can be used by professionals and novices with minimal

knowledge in the dynamic balancing field because it is a very intuitive platform,
and includes tutorial videos and a step-by-step user’s manual.

The

User Interface shows the following data:

Filter amplitude
Maximum amplitude
Overall RMS value
Tachometer
Polar graphs
Real-time graph amplitude vs time
FFT graphs

EI-Balance

2

EI-BALANCE

SINGLE AND TWO PLANE BALANCING SOFTWARE

Easy-to-use

functions

With a single click, you

can perform quick and

accurate balancings

Balancing Tools

2 Polar graphics
Real time FFT spectrum
Multifunction balancing calculator

Balancing Calculator

1 & 2 plane balancing
Split & combine weights
Removing weight drilling
Add mass calculating plate sizes
Calculate new radius for mass
Calculate 1st trial Mass

BALANCING CALCULATOR

Serial Balancings and Residual Unbalance

FFT

Frequency accuracy of 99% with a 10 second
sample
Measurement window (defined by user)
Harmonics, Hz and CPM display
2000 FFT Points in real time, 16,000 3s
recordings, up to 2,00
recording 120s

0,000 FFT Points

3

1 & 2

planes

Dynamic

Balancing

EI-BALANCE

SINGLE AND TWO PLANE BALANCING SOFTWARE

EI-Balance has a calculator for single and 2-plane balancing, this calculator

uses the influence coeicients method. Therefore it is not necessary to esta­blish the rotor’s dimensions and their bearings position (cantilever, between
be

arings, etc.) EI-Balance has a very friendly balancing interface. With a

single click you can start balancing.

E

I-Balance performs its calculations using the Fast Fourier

Transform (FFT). The number of resolution points of the spectra reaches
2 million resolution lines.

4

EI-Balance includes:

EI-BALANCE

SINGLE AND TWO PLANE BALANCING SOFTWARE

2-Channel interface

3 Input connectors: 1-A, 1-B & OP/2 .

Selector button (1-A/ 1-B)

Cable with USB connector (15cm)

Weight 127g

Dimensions (cm): 6(d) x 7.5(w) x 2.5(h)

* Dimensions may vary.

Cables

So Case

Calibrator

Installation CD

& User Manual

2 Accelerometers Laser Optical Sensor

Dynamic Impact Shock: 50g peak (max
shock 5000g)

Freq. response (+/- 3dB): 0.32 - 13 000 Hz

Freq. response (+/- 10%): 2 - 10000 Hz

Sensitivity: 100 mV/g +/- 10%

Transverse sensitivity: < 5%

Power supply: 18-30 V / 3-8 mA

Short-circuit protection

Operation temp.: −10 - 50 °C

Protection grade: IP 68

Impact resistance: IEC 60028-27

Standard 2-Pin MIL connector

Includes 2-Pin to 4-Pin cable and Magnetic
Base

Stainless steel body

Weight 50g

Analogic output / Range: 1 - 5000 Hz

Power and current
supply: 5V , 20 - 30 mA.

Voltage drop: <0.4 V

Short circuit, Reverse Voltage and
Over-Voltage (15V for 1min) protection

Operation distance: 20 cm up to 15 m

Operating temp: −10 - 50 °C

Storing temp: −40 - 85 °C

Protection grade: IP 67, III

Impact Resistance: IEC 60028-27

Weight 60 g

Nylamid body

Soware highlights

Velocity: 0.002 to 3000 mm/s (0.0001 to 120 mm/s)

Lines of resolution: > 2 000 000

Units: Peak, Peak to Peak, RMS in mm/s, in/s

System requirements.

Minimum requirements for the computer or tablet* to install EI-Balance:

Intel ® Celeron ® (1.60GHz / 400MHz FSB) or higher
1GB RAM DDR2 or higher
Windows 10 (compatible with Windows 7,8 & 8.1*)
SVGA display or higher (touch screen supported)
300 MB minimum free hard disk space
USB Port

*Windows RT devices are not supported.

5

EI-BALANCE

SINGLE AND TWO PLANE BALANCING SOFTWARE

Accessories

Increase

capabilities and

performance

with optional

Upgrade to
DigivibeMX

DigivibeMX M10 is the

Dynamic Balancing System
with the most functions on
the market. It is built with
an intuitive interface and

Magnetic

stand

Neodymium magnets for
round and flat surfaces.

accessories

Shielded
Cables

A wide range of shielded
monoaxial cables with 4 or
5 Pin security connectors.
Suitable for Accelerometers
and Optical Sensors.

designed for the most
demanding users.

Upgrading features:

-Balancing reports

-Balancing without trial mass

-Multilanguage

-Intuitive and friendly interface

-Analysis functionalities

-Compatible with 4-Ch interface

6

Hard Case

Weight Scales

Rugged industrial case with
foam to accommodate
your balancing system and
accessories.

Mo

re accessories and spares visit our online store: www.erbessdreliability.com/shop

200 g, 500 g and 1000 g

Service & Support Engineer

1-877-223-4606 /[phone] / 7592-2130

[e-mail]

[e-mail]

Sales

[e-mail]

[e-mail]

Buy Online

www.erbessd-instruments.com

www.erbessdreliability.com

ALL IMAGES ARE FO

ON THE VERSION AND/OR THE IMPROVEMENTS MADE TO THE DEVICES OR COMPONENTS

R ILLUSTRATIVE PURPOSES ONLY. THE FINAL PRODUCT MAY VARY DEPENDING

© 2017 ERBESSD RELIABILITY INSTRUMENTS

D-2017.0223.13