Epson Stylus CX5500 Seris User Manual

Page 1
User’s Guide
— for use without a computer —
Loading Paper
Loading Capacity
Available Paper Paper Size Sheets
Plain Paper
Epson Premium Ink Jet Plain Paper
Epson Bright White Ink Jet Paper
Epson Premium Glossy Photo Paper
Epson Premium Semigloss Photo Paper
Epson Glossy Photo Paper
A4 80
10 × 15 cm
× 6 in.)
(4
20
Placing an Original
Open Close
Copying
Epson Ultra Glossy Photo Paper
Copying Without Borders
Copying Documents
or
Enlarging Documents
Making Draft Copies
or
Press for three seconds
Cancel Copy
+
+
Replacing Ink Cartridges
Checking the Ink Cartridge Status
Open
Removing and Installing Ink Cartridges
Press
Hold y button and press x button
The _ mark indicates a low or expended ink cartridge.
Press
Note:
Do not open the ink cartridge package until you are ready to install it in the printer. The cartridge is vacuum packed to maintain its reliability.
Repeat this step to check other cartridges.
Shake
Close (Click)
Open
Close
Copyright © 2007 Seiko Epson Corporation. All rights reserved. Printed in XXXXXX XX.XX-XX XXX
Remove
Press
Unpack
Only remove the yellow tape
Flashing quickly
Wait about 1 min
Install Click
Epson Ink Cartridges
Color Part Number
Black T0731/T0911
Cyan T0732/T0912
Magenta T0733/T0913
Yellow T0734/T0914
On
Page 2
Troubleshooting
Error Indicators
Lights Cause Solution
& See Loading Paper on the front page.
Prepare a new ink cartridge.
= Flashing, / = On
or
or
Lights Cause Solution
If the paper is not ejected, try the procedures below.
or
Turn off
Sleep mode Press any button except the button to wake the product.
Other lights off
Copy Problems
& See Replacing Ink Cartridges on the front page.
If the light is still on or flashing after you replace the cartridge, try the procedure below.
All lights flashing
All lights on
Waste ink pad in the printer is saturated.
Turn off
A serious error has occurred. Contact your dealer.
Contact your dealer to replace it.
3.0 mm
soft, dry cloth
Close the cover tightly.
Good printout
Problem with printout
& Run a nozzle check
Banding
Faint
1. Nozzle Check
Turn off
2. Print Head Cleaning
Hold down the y button and then press the P button. Hold down both buttons until the P light begins to flash, then release the buttons.
Colors missing
B is off Press for three seconds
Try 1. Nozzle Check
WaitFlashing On
Loading...