Epson S050187 User Manual

EPSON

Material Safety Data Sheet

1. Article and Corporate Identification

Product: Epson Yellow Toner Cartridge S050187

for use with Epson AcuLaser CX11N and

CX11NF Printers

Manufacturer/Distributor: Epson America, Inc.

3840 Kilroy Airport Way
Long Beach, CA 90806
United States
TEL: [phone]
FAX: [phone]

The EPSON S050187 Toner Cartridge

2. Composition Information

Toner is a moist powdered formulation

Ink Composition CAS No. % By Weight

Styrene/acrylate copolymer mixture - 60 – 70%

Mn-Mg-Sr ferrite powder - 10 – 20%

Proprietary acrylic resin - 1 –10 %

Proprietary yellow pigment - 1 –10 %

Amorphous silica - 1 –10%

Carbon Black 1333-86-4 1 –10%

3. Hazard Identification

3.1 Emergency Overview: Toner is a moist yellow powder that may cause eye irritation. Avoid contact with eyes or

clothing. In the case of skin contact, wash with soap and water. Keep out of reach of
children.

3.2 Potential Health Effects:

Eyes: Toner contact with eye may be mildly irritating. See Section 11 for Toxicology.

Skin: Toner contact with skin may cause irritation, swelling, or redness. It is not expected to cause an allergic

skin reaction. See Section 11 for Toxicology.

Inhalation: Intentional exposure to toner may cause respiratory irritation. See Section 11 for Toxicology.

MSDS # S050187 Version 3.5 (USA)
Page 1 of 4 Release Date 10/05

EPSON

Ingestion: May cause upset stomach. See Section 11 for Toxicology.

4. First Aid Measures

4.1 Eyes: Immediately flush with room temperature, low pressure, clean water for at least 15 minutes. Seek

medical attention if eye irritation continues.

4.2 Skin: Wash surface areas with soap and water. Wash soiled clothing before rewearing. Seek medical

attention if irritation continues.

4.3 Inhalation: Remove subject to ventilated fresh air. Consult physician if necessary or if cough develops.

4.4 Ingestion: Rinse mouth with water. Seek medical attention if stomach continues to be upset.

5. Fire Fighting Measures

5.1 Flammability: Flash point is greater than 230 °F / 110 °C (closed cup in accordance with ASTM

D3278)

5.2 Extinguishing Media: Dry chemical or carbon dioxide

5.3 Fire Fighting Instructions: No special fire fighting procedures are required other than breathing apparatus. No

special explosion hazards are known.

6. Accidental Release Measures

Shut off ignition sources. If a spill occurs, use moist sponges to wipe-up toner, then rinse area with damp cloth.
Place waste in closed container for disposal. Use proper ventilation. Do not dispose of waste to the sewer. No eye
or skin protection required during clean-up if toner is not dispersed into air. Wash hands with soap and water.

7. Precautions for Safe Handling and Use

Keep out of reach of children, do not dismantle, and do not incinerate cartridge. Keep cartridge in dark, cool, dry,
and well ventilated area. Do not store cartridges with oxidizing agents. Make sure cartridge is dry before insertion
into printer housing. Avoid dispersing toner.

8. Exposure Controls and Personal Protection

8.1 Engineering Controls: None required when cartridges are used as intended

8.2 Exposure Controls: None required when cartridges are used as intended. Otherwise,

ACGIH TLV (2003): 10mg/cubic meter (total)
3mg/cubic meter (respirable)

8.3 Personal Protection: None required when cartridges are used as intended

MSDS # S050187 Version 3.5 (USA)
Page 2 of 4 Release Date 10/05