Epson PowerLite 825, PowerLite 826W, PowerLite 85 Quick Setup Guide
PowerLite® 85/825/826W
*411676200*
*411676200*
Quick Setup
Before using the projector, make sure you read the safety instructions in the
User’s Guide on your projector CD.
Connect the projector
Choose from the following connections:
Computer Monitor Port
Connect a computer using the VGA cable that came with the projector.
Connect one end to the projector’s Computer1 or Computer2 port, and
the other end to your computer’s monitor port. If you are using a
notebook, switch it to external display. You can also connect an audio cable or
microphone.
Computer USB Port
Connect a computer (Windows® 2000 or later only) using the USB cable that
came with the projector.
Connect the square end of the USB cable to the projector’s Type B
(square) USB port. Connect the flat end of the cable to any USB port on your
computer. You can also connect an audio cable or microphone.
Follow the on-screen instructions to install the Epson USB Display software.
Then press the USB button on the remote control.
Network (LAN)
Connect the projector to your network using an Ethernet® cable. See “Project
Over the Network” on the back of this sheet for more information.
Microphone
Connect a dynamic microphone to the Mic port, using a 3.5 mm mini-jack cable.
Video Player
Connect up to 4 video devices and use the remote control to switch between
them.
Component video
to VGA cable
(optional)
S-Video
cable
(optional)
RCA video cable
(composite video)
(optional)
Audio cable
(optional)
Camera or USB Device
Connect a digital camera, document camera, or other USB device to the
projector’s Type A (flat) USB port.
Digital camera
Thumb drive
DC-06 document camera
If you connect a digital camera or USB storage device, you can use the
projector’s Slideshow feature. See the EasyMP Operation Guide on your
projector CD.
For information on playing sound through the projector or connecting an
external monitor, see the User’s Guide on your projector CD.
Turn on your equipment
Turn on your computer or video source.
1
Plug in the projector.
2
Open the A/V Mute slide all the way.
3
Press the power button on the projector or remote control.
4
Power light
Power button
The power light flashes green, then stays on.
NOTE: To shut down the projector, press the power button twice, then
unplug it. You don’t have to wait for the projector to cool down.
Adjust the image
If you don’t see an image, press the Source Search button on the
1
projector or the Search button on the remote control to select the image
source.
NOTE: If you still see a blank screen or have other display problems, see
the troubleshooting tips on the back of this sheet.
To raise the image, press the blue foot release button and lift the front of
2
the projector. Release the button to lock the foot in position.
Loading...