Epson POWERLITE 1705C, POWERLITE 1715C User Manual

PowerLite® 1705c/ 1 715c

Quick Setup

1 Turn On Your Equipment

1 Connect the power cord to the back of the projector and plug the other

end into an electrical outlet.

2 Open the A/V Mute slide. Make sure the slide is opened completely.

3 Remove the battery cover on the remote control. Locate the two AAA

batteries that came with the projector and insert them. Then replace
the battery cover.

4 To turn the projector on, press the Power button on the projector or

the remote control. The projector beeps once, and the projector’s
Power light flashes green and then stays on.

Power button

CAUTION: Before unplugging the projector...

Shut the projector down properly:

1. Press the Power button twice.

2. When the orange light stops flashing and the projector beeps,
you can unplug the projector.

2 Adjust the Image

1 To raise the image, press the blue foot release button for the front

adjustable foot and lift the front. Release the button to lock the
foot in position.

2 Turn the focus ring to sharpen the image.

Turn the zoom ring to reduce or enlarge the image.

Focus

Zoom

3 If your image looks like

to one side of the screen at an angle. Place it directly in front of the
screen, facing the screen squarely.

4 If your image looks like

the projector to correct it.

or

or

, you’ve placed the projector off

, press the

or

buttons on

3 Choose a

Presentation Method

How do you want to get images to the projector?

• To connect to a notebook, see “If connecting

to a notebook” below.

• To project over a wireless network, see

“If projecting wirelessly” on the back of this sheet.

You must have installed the projector’s EasyMP™ software and

configured your projector and computer before you can project
wirelessly. See your User’s Guide for instructions.

• To give a presentation stored on a flash drive, digital camera, or

other USB storage device, see Chapter 5 in your User’s Guide.

• To connect to your notebook using the included USB cable, see

your User’s Guide.

Computer cable

If connecting to a notebook...

1 Make sure you’ve turned on the projector and adjusted the image

as described in sections 1 and 2.

2 Locate the computer cable that came with the projector. Connect

one end to the projector’s blue Computer (Component Video)
port.

Connect the other end to your notebook’s video-out port or

monitor port.

3 Press the Source Search button on the projector or the remote

control until your computer image is displayed.

Turn over