Epson PictureMate Deluxe Viewer Edition Start Here Card

Start Here

®

Set up your PictureMate and

4051812-00 XXX

print–no computer required!

Note: To print from your computer, see Using PictureMate With a

Computer and your CD after completing these steps.

1 Unpack

PictureMate comes with all these items in the box.

Remove all the tape and packing material from PictureMate,
including the plastic film on the photo viewer screen.

Power adapter

PictureMate

Deluxe Viewer Edition

Power cable PictureMate

PictureMate
Photo Paper

Photo Cartridge

Using PictureMate

Without a Computer

booklet

Note: If you purchased the optional PictureMate Deluxe Viewer

Edition battery, see Using PictureMate Without a Computer for
instructions. Make sure you install the photo cartridge and plug in
the AC adapter and power cable before installing the battery.

Caution: To avoid damaging your PictureMate,

keep it out of the sun and don’t leave it in your
car or other location where it can get too hot or
too cold.

*410098700*

*410098700*

Printed in XXXXXX XX.XX-XX XXX

PictureMate

Software

CD

Using PictureMate

With a Computer

+

booklet

2 Install the Photo

Cartridge

1 Open the cartridge door on the back of PictureMate.

You see the release lever.

Release lever

2 Move the lever to the Release position by sliding it

in the direction shown.

To release lever

3 Shake the photo cartridge a few times in its package,

then unwrap the cartridge.

4 Slide the cartridge straight into the slot, label side up,

until it is fully inserted. Push in both sides evenly to
make sure it is not crooked.

Caution: Make sure both sides of the cartridge are even,

or ink may leak. If either side is sticking out, remove the
cartridge and reinstall it.

WrongRight

5 Move the lever right to the Lock position. If it does

not lock in place, the cartridge is not installed
correctly. Release it and try again.