Product Support Bulletin
Subject:
Date: 2/7/90 PSB No: P-0060
Page: 1 of 2
The following information is a list of the power requirements for
the Epson 9 and 24 pin printers and laser printers.
Power Specifications
Originator: RFB
504
VA maximum
Product
1
Voltage
PSB No: P-0060
Page: 2 of 2
Max. Current
1
Consumption1 Power Consumption 1 BTU/HR
LX810
T750 120V 1.0
T1OOO
If the power requirements of a particular Epson printer is not listed please
refer to the appropriate User's Manual for the electrical specifications.
In the event that the User's Manual is not available, locate the silver label
on the back of the Epson printer. This is a reliable source for the electrical
requirements. The following formula is used to calculate the electrical
power requirements:
VOLTAMPS is equivalent to WATTS
VOLTAMPS = Volts * Amps
AMPS
BTU/HR
Example:
120V *
120VA/120V
120VA is equivalent to 120W
120W * 3.413 = 409.56 BTU/HR
= Voltamps/Volts
= Watts * 3.413
1A
120V
1
120V
= 120VA
= 1A
.7 Amp
Amp
.7
Amp
84 VA maximum
120
VA
maximum
84 VA
maximum
I
286.69
409.56
286.69
Heat output is rated in BTU/HR.
EPSON
8?801
8.rvl.0
AYLRICA,
0lvl.1.r
PRODUCT SUPPORT BULLETIN
INC.
DATE: 04/24/87
SUBJECT: FX-86e/286e PAPER DETECTION
The following information should clarify how the FX-86e/286e
paper detection and auto load system operate.
The key to paper detection is
and the beeper will not activate
to transmit data to the printer. See examples below.
* If
* If the FF was sent by software,
The key to the auto load system is that the printer must be
off line to operate.
there is a FF which
the last sheet of a continuous form,
indicator will not turn on
until there is an attempt to transmit data to the printer.
line until there is an attempt to transmit data to the
printer.
ejects a single sheet of paper or
that the paper
unless there is an attempt
and the beeper
the printer will remain on
NUMBER: P-0004
empty light
the paper out
will not beep
* To use the auto load feature under the above circumstance,
the printer must first
the paper bail lever should be pulled to load
then press
ON LINE to continue printing.
be manually taken off line, then
the sheet,
Loading...