Epson C831 User Manual

USER MANUAL
Longitudinal Label Slitter
for EPSON C831
this product is certified:
INSTALLATION
STEP 1
Assemble the printer plate.
STEP 2
Connect the slitter to the printer plate.
Label Unwinder
(optional)
STEP 3
STEP 4
Place the core holder in position. The grey handle must match with the grey holder.
Paper Path
Label face out Label face in
Finished roll
from
printer
Waste
STEP 5
Attach the labels to the cores. This will provide the necessary tension in order start the slitting process.
STEP 6
Align the blades with the edges and the center of the labels, tighten the thumb screw once the blade is in position. You can alternate the position of the thumb screws for easier access.
WARNING: The slitter blades are exposed and are VERY
sharp when the slitter station is in the “up” position. Use extreme caution!
A
A
B
C
OPEN CLOSE
B C
Slitter module has 3 positions:
- Upper position (A), the blades are closed to allow the media loading;
- Middle position (B), align the blades with the edges and the center of the labels, tighten the thumb screw once the blade is in position;
- Lower position (C), the blade cut the media.
The black knobs lock the slitter module in the requested position. Screw the thumb knobs to move the blades to the right or to the left.
STEP 7
Switch on the Slitter. Slowly turn the speed knob. Run the slitter until the labels reach the bottom of the take-up core holder. Remove the labels that have rewinded onto the take-up core holder.
STEP 8
Attach the labels to the core using a waste label or tape.
Switch on the slitter and slowly turn to increase the speed.
Now you can start to print.
HOW TO ADD OR REMOVE A BLADE HOLDER
1
Keep out the iron slide bar unscrewing the thumb screw.
REPLACING SLITTER BLADES
2
Slide in or out the blade holder. Relocate the slide iron bar in its position and rescrew the thumb screw.
Loosen the two screws holding the blade in place.
Replace the blade.
Fix back the screw to holding the blade in place.
REWINDER GUIDES ALIGNMENT
ULTRASONIC SENSOR CALIBRATION
Metal glides adjustable to obtain rolls of labels perfectly aligned.
WARNING: Before proceeding with the ultrasonic sensor
calibration, turn “OFF” the module that needs to be calibrated (laminating or matrix removing).
1. Take a paper clip and insert it into the little hole located next to the OFF-ON switch and push it down for 5 seconds. The yellow led will light up.
2. Raise the tension arm. The yellow led will stay on.
3. Once again, insert the paper clip down into the hole for 5 seconds. The led will
light o󰀨.
Ultrasonic sensor calibration complete.
LAMINATION / MATRIX REMOVER & SLITTER MODULES SPEED ROTATION
MATRIX REMOVER & SLITTER MODULE
ULTRASONIC TENSION CONTROLLER
WARNING: If what (pictured above) is not happening, please
press the button on circuit board untill the yellow led ashes. After it ashes for 5 times release the button and perform a
new test.
smart solutions for the labeling industry
Label rewinder, label unwinder, electronic label dispenser and more...
- FOR MORE INFO CONTACT YOUR RESELLER -
Loading...