COMPACT CHARGER
INSTRUCTION MANUAL
IMPORTANT SAFETY INSTRUCTIONS:
•For Nickel Metal Hydride (NiMH) and Nickel Cadmium (NiCd) rechargeable AA, AAA 9V batteries only.
•Never charge NiCd and NiMH batteries together.
•Do not use to charge Alkaline, Carbon Zinc, Lithium or any other kind of battery not specified on the charger.
•Remove the batteries from the unit once they are charged, and disconnect the charger from the power outlet.
•Automatic charging current control for different battery sizes (NiMH only)
•For indoor use only.
OPERATING INSTRUCTIONS:
1.Insert batteries in the charger respecting the polarity (+/-). If the polarity is reversed, the charger has a safety protection and will not start charging. See Picture B for how to insert the batteries into the compartments.
2.Load either:
AA/HR6/RC6/Mignon |
2 or 4 pieces at a |
|
time |
AAA/HR03/RC3/Micro |
2 or 4 pieces at a |
|
time |
9V/HR22/E-Block |
1 or 2 pieces at a |
|
time |
DO NOT MIX THE BATTERY SIZES & CAPACITIES IN SAME CHANNEL WHILE CHARGING.
3.Plug the charger into a correct household electric outlet. The red LED will illuminate indicating that charging is in progress.
4.If NiMH batteries are charged, after the pre-set charging time is reached, the red LED will turn off.
5.If NiCd batteries are charged, the charging operation is manually controlled (refer to charging-time table for guidance). The red LED does not automatically switch-off after charging. Switch off the unit and manually remove the battery after charging. Do not exceed manual charging times.
6.After use, disconnect the charger from the outlet and remove the batteries. ALWAYS UNPLUG BETWEEN CHARGES.
Loading...