Eneo VKCD-134-HR B User Manual
VKCD-134HR/B, VKCD-135HR/B
HIGH PERFORMANCE
MINIATURE DOME CAMERA
Thank you for choosing our high quality camera. Before
attempting to connect or operate, please read and follow
these instructions.
OPERATION MANUAL
CAUTIONS
These servicing instructions are for use by qualied service personnel only. To reduce the risk of electric shock do not perform any servicing other than
that contained in the operating instructions unless you are qualied to do so.
In USA and Canada, Use Class 2 Power Supply Only.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
Note -
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will
be required to correct the interference at his own expense.”
WARNING -
This is a class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take adequate
measures.
Caution -
Any changes or modications in construction of this devies which are not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
1. A regulated DC12V/DC5V 300mA power supply is recommended for use with this camera for the best picture and the most stable operation.
An unregulated power supply can cause damage to the camera. When unregulated power supply is applied,
product warranty will be out of subject.
2. It is recommended that the camera is used with a monitor that has a CCTV quality 75 video impedance level. If your monitor is switched to high
impedance then please adjust accordingly.
3. Do not attempt to disassemble the camera to gain access to the internal componets. Refer servicing to your dealer.
4. Never face the camera towards the sun or any bright or reective light, which may cause smear on the picture and possible damage to the CCD.
5. Do not remove the serial sticker for the warranty service.
CAUTION
(Waste Electrical & Electronic Equipment)
WEEE
This marking shown on the product or its literature, indicates that it
should not be disposed with other household wastes at the end of its
working life. To prevent possible harm to the environment or human
health from uncontrolled waste disposal, please separate this from
other types of wastes and recycle it responsibly
to promote the sustainable reuse of material resources. Household
users should contact either the retailer where they purchased this
product, or their local government ofce, for details of where and
how they can take item for environmentally safe recycling.
Business users should contact their supplier and check the terms
and conditions of the purchase contract.
This product should not be mixed with other commercial wastes for
disposal.
RISK OF ELECTRIC SHOCK DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK). NO USER
SERVICEABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED SERVICE PERSONNEL
This symbol is intended to alert the user to the presence
of un-insulated “dangerous voltage” within the product’s
enclosure that may be of sufcient magnitude to constitute a
risk of electric shock.
This symbol is intended to alert the user to the presence of
important operating and maintenance (servicing) instructions
in the literature accompanying the appliance.
CAUTION
IMPORTANT SAFETY INSTRUCTIONS
1) Read these instructions.
2) Keep these instructions.
3) Heed all warnings.
4) Follow all instructions.
5) Do not use this apparatus near water.
6) Clean only with dry cloth.
7) Do not block any ventilation openings. Install in accordance
with the manufacturer’s instructions.
8) Do not install near any heat sources such as radiators, heat
registers,stoves, or other apparatus (including ampliers) that produce heat.
9) Do not defeat the safety purpose of the polarized or
grounding- type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades
and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not
t into your outlet, consult an electrician for replacement of the obsolete outlet.
10) Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the point where they exit from the apparatus.
11) Only use attachments/accessories specied by the manufacturer.
12) Use only with the cart, stand, tripod, bracket, or table specied by
the manufacturer, or sold with the apparatus. When a cart is used,
use caution when moving the cart/apparatus combination to avoid injury from tip-over.
13) Unplug this apparatus during lightning storms or when unused for long periods of time.
14) Refer all servicing to qualied service personnel. Servicing is
required when the apparatus has been damaged in any way, such as power-supply cord or plug is damaged, liquid has
been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not
operate normally, or has been dropped.
EQUIPMENT AND ACCESSORIES
Camera
Video Outout
Cable
Screw 4ea
Operation Manual
&
LEAD
cable
SPECIFICATION
Signal Format PAL
Image Device 1/3” 960H SONY Super HAD CCD II
Scanning System 2 : 1 Interlace
H.Resolution 700TV Lines
Scanning Frequency 15.625KHz(H),50Hz(V)
Total Pixels 1020(H) X 596(V)
Effective Pixels 976(H) X 582(V)
Electronic Shutter Speed 1/50 ~1/100,000sec
S/N Ratio
Gamma
Min. Illumination
Sync System
Video Output
White Balance
Lens
2DNR
Power Consumption
Operating Temperature
Storage Temperature
Humidity
Dimension(mm)
Specications and designs are subject to change for improving the
functionality of this product without notice.
More than 50dB(AGC OFF)
r= 0.45
0.1 Lux / F2.0
Internal
1.0 Vp-p Composite(75Ω)
PUSH
Fixed Pinhole
DC12V(±10%), Max. 90mA 210mA
AUTO
-10°C~+50°C
-20°C~+60°C
Less than 80%
Wall mount type : 47Ø x 45(H)
Ceiling Mount type : 65Ø x 45(H)
CONNECTION ANGLE OF VIEW
R (DC12V / DC5V)
Camera
Camera
When you install the camera, please glue up the end of cable to
keep it stable in order to protect the camera from the humidity problems.
INSTALLATION
WALL MOUNT
1.
CEILING MOUNT
2.
B (GND)
Y (VIDEO)
Lead Wire Connection
BNC(RCA)
Video
DIY Cable Connection
Front case
Female
Lens
TV
Monitor
DC12V/DC5V Regulated
Power Supply
DC12V/DC5V Regulated
Power Supply
TV
Monitor
Video in
Cable
Ball camera
Fixing screw
Fixture drum
Ceiling or Wall
360˚
60˚ 60˚
1. Camera revoves 360˚
2. Camera ball is adjusted to max 60˚ from the
axis to each end of the front case.
3. Viewable angle of the camera lens is 90˚(Standard)
* 78˚ is available as an option.
90˚
DIMENSIONS
Unit(mm)
1.
WALL MOUNT
Ø46.5
Ø2.7
(Ø31.5)
2.
CEILING MOUNT
Ø65
Ø2.7
(Ø31.5)
Ø55
45
TOP View
3-Ø3.5
SIDE View
45
Loading...