Emerson TBSR600 Owner's Manual

xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx

Remote Control
Model Number:

TBSR600

For Use With RCK55, RC188 or RC212 Receivers

(sold separately)

Part No. F40BP74190000 Form No. BP7419

READ AND SAVE THESE INSTRUCTIONS

Ceiling Fan/Light

Remote Control Owner's Manual

General

Your Emerson Ceiling Fan/Light TBSR600
Remote Control consists of hand-held
transmitter and a receiver which is mounted
under the fan ceiling cover. The remote control
is designed to separately control your ceiling
fan speed and light intensity.

The remote control transmitter is powered by
two AAA alkaline batteries (included). To
prevent possible damage if the batteries should
leak, be sure to remove the batteries when the
control is not to be used for an extended period
of time.

Code switches in the transmitter and receiver
may be set in 32 different positions. If your fan
and light go on and off without using your
control, you may be getting interference from
other remote units such as garage door
openers, car alarms or security systems. To
remedy this situations, simply change the
combination code in your transmitter and
receiver.

2

Safety Instructions

WARNING: To avoid fire, shock, and serious personal injury, follow all instructions carefully.

1. Read your Owner's Manual carefully before installing the Remote Control. Retain
Owner's Manual for future reference.

2. Before servicing or cleaning the ceiling fan, switch power off at service panel and lock
service panel to prevent power from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten a warning device such as a tag,
to the service panel.

ADDITIONAL SAFETY INSTRUCTIONS FOR INSTALLATION

1. To avoid possible electrical shock, be sure electricity is turned off at the main fuse or
circuit breaker box before wiring.

2. Make certain no bare wires are exposed outside the wire connectors.

3. All wiring must conform to National and Local Electrical Codes.

4. Follow the recommended instructions for the proper method of installation of your new
Remote Control. If you feel you do not have enough electrical wiring knowledge or
experience, have your Remote Control installed by a licensed electrician. Any electrical
work not described in this manual should be performed by a licensed electrician.

DATE CODE:

The date code of this fan may be found on the box, stamped in ink on a white label.
You should record this data above and keep it in a safe place for future use.

TBSR600 REMOTE CONTROL PROCEDURES

!

WARNING

Installation of Battery

1. Remove the battery cover by pressing

firmly below the arrow and sliding the
cover off the control (Figure 1).

2. Install two AAA alkaline batteries and

reinstall the battery cover.

Preset Memory Feature

Your Emerson receiver is equipped with a
preset memory feature. If the AC supply to the
receiver is powered through a wall switch,
when the switch is turned OFF, the control will
remember the light intensity and fan speed.
When the switch is turned back ON the light
and fan will resume operation as they were
prior to the switch being turned OFF.