Emerson SB160 User Manual

LOCATION OF CONTROLS

BATTERY INSTALLATION

1. Open the battery compartment by sliding it down and insert two

(2) "AA" size batteries (not included), following the polarity
diagram.

2. Slide the battery compartment cover back into place.

USING BASS BOOST SWITCH

To increase the Bass Response, slide the BBS(Bass Boost) switch
to the "ON" position.

TO PLAY A PRERECORDED CASSETTE

• Insert a prerecorded tape with the open surface as
shown.

•

Close the Cassette Door and plug the headphone
into the PHONES jack.

•

Set the VOLUME control to minimum and press
the PLAY button.

• Adjust the VOLUME and BBS(Bass Boost) switch
as desired.

• To stop the tape before it reaches the end, press
the STOP button.

TO FAST FORWARD A TAPE

To rapidly advance the tape, press the F. FWD button. To rapidly
advance the tape while in the Play mode, press the STOP button
before pressing the F. FWD button.

TO REWIND A TAPE

To rewind an already played cassette tape, remove the tape from
the compartment, flip it over to the other side, reinsert it in the
compartment and press the F. FWD button. When you have
forwarded it enough, press STOP, remove the cassette again and
flip it over to the original side to repeat the played portion.

AUTOMATIC STOP

This cassette player has a built-in Automatic Stop System that
stops the tape when it reaches the end in both the Play and F.Fwd
modes.

CASSETTE TAPE USAGE

Longer length tapes of 60 (C-120) minutes
of recording time on each side are not
recommended. These tapes used thinner
material and have a greater chance of
malfunction, such as tape spillage from the
cassette, internal binding and tape tearing.
Use only high quality tapes. If there is any slack in the tape in the
cassette, it should be removed before inserting the cassette. Place
a pencil in one of the hubs and rotate toward the outside of the
cassette until all slack is taken up.

CARE AND MAINTENANCE

Clean the tape head, capstan and pinch
roller using a cotton swab slightly
moistened with alcohol. Avoid scratching
the head surface. To clean the unit
housing, use a soft cloth slightly
dampened with water and wipe dry.

CAUTION: Never use chemicals such as benzen e or paint
thinner for cleaning, otherwise the case may be deformed
or discolored.

1. BBS(Bass Boost) Switch.

2. VOLUME Control.

3. PHONES (Headphone) Jack.

4. Belt Clip.

5. STOP Button

.

6. PLAY Button.

7. F.FWD (Fast Forward) Button.

8. Cassett e Door.

9. Battery Compartment
(rear of unit).

Cotton Swab

Capstan

Play Head

Pinch Roller

BATTERY PRECAUTIONS

Follow these precautions when using batteries in this device:

1. Use only the size and type of batteries specified.

2. Be sure to follow the correct polarity when installing the batteries as
indicated in the battery compartment. Reversed batteries may cause
damage to the device.

3. Do not mix different types of batteries together. (e.g. Alkaline and
Carbon-Zinc).

4. If the device is not be used for a long period of time, remove the batteries
to prevent damage or injury from possible battery leakage.

5. Do not try to recharge batteries not intended to be recharged; they can
overheat and rupture.(follow battery manufacturer's directions).

MOD

Stereo Cassette Player

EL :

SB160

3
2

1

4

8
9

6

5 7

Copyright 2004 Viacom International Inc. All Rights Reserved. Nickelodeon, SpongeBob
SquarePants and all related titles, logos and characters are trademarks of Viacom
International Inc. Created by Stephen Hillenburg.

TRAFFIC

AND HEADSET SAFETY

•

Do not use while operating a motorized vehicle. It may create a traffic hazard and is illegal in many areas.

• Even if your headset is an open air type designed to let you hear outside sounds, do not turn the volume up so high that you
cannot hear what is around you.

• Use extreme caution or temporarily discontinue use in potentially hazardous situations.

• Do not play your headset at a high volume. Hearing experts advise against continuous extended play.

•

If you experience a ringing in your ear, reduce volume or discontinue use.

EMERSON RADIO CORP.

LIMITED WARRANTY

Emerson Radio Corp. warrants manufacturing defects in original material, including original parts and workmanship,
under normal use and conditions, for a period of ninety (90) days from the date of original purchase in the U.S.
With your dated proof of purchase, we will provide repair service at no charge for labor and parts at an authorized
Depot Repair Facility, or replace the product in our discretion. For repair or replacement, pack your unit in a
padded box, enclose your check or money order payable to Emerson Radio Corp. in the amount of $5.00 (not
required by California residents) to cover shipping and handling costs, and enclose a copy of your proof of pur­chase. Send your unit to:

Emerson Radio Corp.

1901 Diplomat Drive

Farmers Branch, TX 75234

This warranty does not cover damage from negligence, misuse, abuse, accident, failure to follow operating instruc­tions, commercial use, rental, repairs by an unauthorized facility, or products purchased, used, serviced or damaged
outside of the United States.

THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS, AND YOU MAY ALSO HAVE OTHER RIGHTS WHICH
VARY FROM STATE TO STATE.

AU898H
Part no.: 21-2056 Printed in China
401-01