Elvid FBP-F970, FBP-LPE6, FBP-PD28 User manual

MONITOR BATTERY PLATE

For Sony L-Series, Canon LP-E6,
and Panasonic D28 batteries

USER
MANUAL

FOR: FBP-F970 / FBP-LPE6 / FBP-PD28

INSTRUCTIONS

Installing the Battery Plate

Before proceeding, remove the battery from your Elvid
monitor, and make sure that the monitor is unplugged and
turned off.

1. Use a Phillips-head screwdriver (not included) to
unscrew and remove your Elvid monitor’s existing
battery plate, including the wires connecting it to the
back of the monitor.

2. Place the Elvid FBP battery plate’s red wire on the
positive terminal, and the black wire on the negative
terminal. Insert the two included big screws into the
terminals, and use a Phillips-head screwdriver to
fasten them until fully tightened. Be careful not to
overtighten.

3. Position the FBP battery plate with the open side
facing the top of the monitor. Align the battery plate’s
screw holes with the monitor’s screw holes. Make
sure the battery plate covers the red and black wires
completely and that no part of the wires is exposed.

2