Elkhart Brass 08394053 User Manual
1
1302 WEST BEARDSLEY AVE • ELKHART, IN 46514 • 574-295-8330 • 800-346-0250 98343000 REV D
© 2014 ELKHART BRASS MFG. CO., INC. • WWW.ELKHARTBRASS.COM
08394053 Monitor
Installation, Operation, & Maintenance Instructions
2
TABLE OF CONTENTS
PRODUCT SAFETY INFORMATION 3
MONITOR CALLOUT DRAWING 4
OVERVIEW 5
INSTALLATION INSTRUCTIONS 6
OPERATING INSTRUCTIONS 8
MAINTENANCE 8
SPECIFICATIONS 9
MONITOR HYDRAULIC DATA 9
DIMENSIONAL DRAWINGS 10
WIRING 11
3
PRODUCT SAFETY INFORMATION
All personnel who may be expected to operate this equipment must be thoroughly trained in its safe
Important: Before installing and operating this equipment, read this manual
thoroughly. Proper installation is essential to safe operation.
Warning: Do not attempt to disconnect or work on any electrical equipment in this
system unless power is removed or the area is known to be non-hazardous.
and proper use.
Before flowing water from this device, check that all personnel (fire service and civilian) are clear of
the stream path. Also confirm stream direction will not cause avoidable property damage.
Become thoroughly familiar with the hydraulic characteristics of this equipment, as well as the
pumping system used to supply it.
Whenever possible, this equipment should be operated from remote location to avoid exposing
personnel to dangerous fire conditions.
Always open and close valves slowly to avoid water hammer.
After each use, and on a scheduled basis, inspect equipment per instructions in the maintenance
section.
Keep fingers and hands clear of moving parts.
Disconnect power before servicing and electric valve or electric valve controller.
Any modifications to the electrical will destroy the NEMA 4 rating and void warranty coverage of the
enclosure and all components within.
All equipment must be installed in accordance with local codes (NFPA 70 or EN/IEC 60079-14) as
appropriate and in areas where equipment classification is suitable.
MONITOR INFORMATION:
SERIAL NUMBERS:__________________________________________________________________________
DETAILS:
__________________________________________________________________________________________
__________________________________________________________________________________________
__________________________________________________________________________________________
__________________________________________________________________________________________
__________________________________________________________________________________________
4
MONITOR CALLOUT
Figure 1: Monitor Callout Drawing
Pressure Gauge
Constant Torque /
Constant Current Motors
Manual Override
Double Race Bearings
Junction Box
4”-150# ANSI Flange
Loading...