Elkay HRC2-10-2C Installation Manual

HRC2-10-2C

Installation Instructions

Refrigeration Packages

NOTE: It is important to insure proper ventilation. Allow a minimum clearance of 6 inches (152 mm) in front and 3 inches (76mm) in the rear of the unit. If unit is to be installed in an enclosure, allow the following clearances around unit 1 inch (25mm) each side, 3 inches (76mm) in the rear, 3 inches (76mm) inches above wall.

This chiller has been designed for use with potable water and includes an o-ring seal on the drain plug. This fitting should be replaced if the unit is to be used with more aggressive fluids.

LEGEND:

A = 3/8" O.D. TUBE WATER OUT B = 3/8" O.D. TUBE WATER INLET C = 3/8" O.D. TUBE TANK DRAIN D = TEMPERATURE ADJUSTMENT E = ELECTRICAL

97735C(4/01)

ITEM

NO.

1 2 3 4 5 6 7 8 9

11*

12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28

ITEMIZED PARTS LIST

10 GPH

PART NO.

27666C 31513C 31430C 30664C 20282C 70018C 70009C 66305C 50189C 66203C 36021C 30262C 36019C 30233C 30235C 30234C

19037000

100806740570

66619C 27665C 70772C 27670C 27663C 27662C 27664C 27667C 35882C 27669C 27668C

Cover - Terminal Box Control - Cold Motor - Fan Fan - Blade Fan - Bracket Fan - Nut Screw - Motor Mounting Condenser Shroud Drier Compr. Serv Pak Relay Overload Overload Spring Cover - Terminal Compr. Bale Strap Clip Grommet Evaporator - Assy Cover - Insulation Box Drain Plug Base Assy Panel - Insul Box (Rear) Panel - End Box - Insulation (Front) Terminal Box Assy Control-Freeze Protect Grille - Front Grille - Rear (Not Shown)

HRC2-10-2C

DESCRIPTION

*INCLUDES RELAY & OVERLOAD. IF UNDER WARRANTY, REPLACE WITH SAME COMPRESSOR USED IN ORIGINAL ASSEMBLY. NOTE: All correspondence pertaining to any of the above water cooler or orders for repair MUST include model number and serial number of cooler, name and part number of replacement part.

NOTE: For use with photo processing applications, adjust thermostat to warmer settings.

8,9

3, 4, 5, 6, 7

12,13, 14, 15, 16

97735C (4/01)

17,18