Elkay HAC, HVR, HVRGRN, EMABF, VRC Installation Manual

Installation Instructions

Cane Touch Apron Replacement Kits

This kit is designed to be used with:

HAC, HVR, HVRGRN, EMABF, VRC & VRCGRN models manufactured after July 2007.

Installation Procedure:

1.Using cane apron as a template use a center punch to mark hole locations on front of left and right side panels.

2.Drill 1/8” diameter holes at marked locations. (Center punch hole locations before drilling). When drilling the right hand hole on refrigeration units, be certain to drill straight.

CAUTION: Keep the drill bit away from the refrigeration condenser. If the drill damages or punctures the condenser refrigeration tubing severe and expensive damage to the refrigeration system will result.

3.Loosen and remove (2) front screws from underside of cooler dispenser panels.

4.Install cane touch apron to underside of cooler dispenser panels and reuse fasteners removed in step 3 above.

5.Attach lower edges of apron to cooler side panels with screws provided. (Using two holes drilled in step 2 above)

STYLE OF COOLER

MAY VARY

Required Tools:

To install this kit the following tools are required:

•Phillips Head Screwdriver

•Pinned Torx Head Driver

•Power Drill with 1/8” Drill Bit

•Hammer and Center Punch

CANE TOUCH APRON REPLACEMENT KITS

(COLOR OPTIONS)

*KIT PART NO.	FINISH
98324C	Stainless Steel (For all Models)
98312C	Platinum Vinyl (HAC/HVR)
98313C	Light Gray Vinyl (EMABF/VRC)

*Kits consist of cane apron, screws and pinned torx bits.

UNIT W/O REFRIG.

SHOWN

CANE TOUCH

APRON

1/8" DIA. HOLE (2) SCREWS PROVIDED (SEE NOTE 2)

(SEE NOTE 5)

www.elkay.com	For purchasing Replacement Parts, please contact us at #800.834.4816
www.halseytaylor.com	For Technical Questions, please contact us at #800.476.4106

98379C Rev B - (06/16)