Elkay HRC2-10-1D User Manual

HRC2-10-1D

Installation Instructions

Refrigeration Packages

NOTE: It is important to insure proper ventilation. Allow a

minimum clearance of 6 inches (152 mm) in front and 3 inches (76mm) in the rear of the unit. If unit is to be installed in an enclosure, allow the following clearances around unit 1 inch (25mm) each side, 3 inches (76mm) in the rear, 3 inches (76mm) inches above wall.

This chiller has been designed for use with potable water and includes an o-ring seal on the drain plug. This fitting should be replaced if the unit is to be used with more aggressive fluids.

LEGEND:

A = 3/8" O.D. TUBE W A TER OUT B = 3/8" O.D. TUBE WA TER INLET C = 3/8" O.D. TUBE T ANK DRAIN D = TEMPERA TURE ADJUSTMENT E = ELECTRICAL

98244C (3/06)

ITEM

NO.

1 2 3 4 5 6 7 8 9

11*

13 14

15 16 17 18 19 20 21 22 23 24 25 26

ITEMIZED P ARTS LIST

10 GPH

PA RT NO.

27666C 31513C 31490C 30664C 20282C 70018C 70009C 66305C 50189C 66203C 35774C 35818C 36222C 35795C 30180C 36221C 35806C 31797C 30181C 30182C

19037000

100806740570

66311C 27665C 70772C 28399C 27663C 28400C 27664C 27667C 35882C 27669C 27668C

Cover - Terminal Box Control - Cold Motor - Fan Fan - Blade Fan - Bracket Fan - Nut Screw - Motor Mounting Condenser Shroud Drier Compr. Serv Pak Embraco Compr. Serv Pak Tecumseh Overload (Embraco) Overload (Tecumseh) Overload Spring (Tecumseh) Relay (Embraco) Relay (Tecumseh) Cover - Relay (Embraco) Cover - Term (Tecumseh) Compr. Bale Strap (Tecumseh) Clip Grommet Evaporator - Assy Cover - Insulation Box Drain Plug Base Assy Panel - Insul Box (Rear) Panel - End Box - Insulation (Front) Terminal Box Assy Control-Freeze Protect Grille - Front Grille - Rear (Not Shown)

HRC2-10-1D

DESCRIPTION

*INCLUDES RELA Y & OVERLOAD. IF UNDER W ARRANTY , REPLACE WITH SAME COMPRESSOR USED IN ORIGINAL ASSEMBLY. NOTE: All correspondence pertaining to any of the above water cooler or orders for repair MUST include model number and serial number of cooler, name and part number of replacement part.

NOTE: For use with photo processing applications, adjust thermostat to warmer settings.

8,9

3, 4, 5, 6, 7

12,13,14

98244C (3/06)

15,16