ELK P983 User Manual
Power Supply for Uplink 2500
Enclosure and 12 Volt Power Supply for
Uplink 2500 Cellular Alarm Transceiver
ELK-P983
APPLICATION
The ELK-P983 is ideal for mounting and powering the Uplink
2500 Cellular Alarm Transceiver. It consists of a 12" x 12"
metal enclosure and a 12 Volt DC power supply/battery
charger. It is capable of supplying 1 Amp of continuous
current and 2.5 Amps peak for brief high current demands of
the radio during transmission. The design of the enclosure
allows quick and easy field mounting of the transceiver and
antenna.
FEATURES
• Supplies 12 Volts D.C. Power for Transceiver
• Current: 2.5A Peak, 1A Continuous
• Heavy Duty Metal Enclosure
• Requires a 16.5 VAC, 45 VA Transformer (not supplied)
Features and Specifications subject to change without notice.
Uplink 2500 Cellular
Alarm Transceiver
Plastic Strap
INSTALLATION
1. Remove the 7/8" metal knockout (2nd from the left) on the
top side of the enclosure. This hole is for the Antenna.
2. Install the Antenna on the Uplink Radio, then place the unit
inside the enclosure on the left side with the antenna
protruding through the knockout hole.
3. Locate the plastic strap supplied with the Uplink Radio.
Place the strap across the housing and line it up with the
two (2) mounting holes in the back of the enclosure.
5. Secure the bracket and radio using two (2) sheet metal
screws (not supplied).
6. Connect a 16.5VAC, 45VA AC Transformer (not supplied) to
the AC terminals on the ELK-P624 power supply.
7. Connect the Power Output Terminals of the ELK-P624 to
the 12VDC inputs on the Uplink Radio. Observe POLARITY!
NOTE: Be certain the ELK-P624 is configured for 12VDC.
8. Connect the Uplink Radio to other alarm equipment per the
instructions packed with those products.
JP1
JP1 ON
JP2
JP2 OFF
Do Not Move Jumpers
Refer to the Cellular Transceiver
Instructions for Connections
Ample room for up to two (2) 7or 8Ah Rechargeable Batteries (Not
Supplied)
ELK-624 12V POWER SUPPLY
- +
AC
TRANSFORMER
DC OUTPUT
AC DC
LEDS
-
+
BATTERY
Transformer Not
Supplied
16.5 VAC
45 VA
(c) 2009 Uplink Security LLC. All rights reserved. For Uplink Technical Support call 1-888-9 Uplink (888-987-5465).
P.O. Box 100 • Hildebran, NC 28637 USA • 828-397-4200 • 828-397-4415 FAX
http://www.elkproducts.com • email: info@elkproducts.com
4/12
Loading...