Electro-Voice TS992-LX User Manual

R

Systems

Description

The TS992-LX is a Digital Dynamics
Capable
biamplification. It is designed for absolute
minimum depth—only 254 mm (10 in.)
deep—but with performance as close as pos­sible to the large-format, THX
TS9040D-LX. Electro-Voice has combined
its expertise in constant-directivity horns,
high-frequency compression drivers and low­frequency reproducers to produce a stage sys­tem with superior performance in all areas:
uniform dispersion to the highest frequencies,
high efficiency, high power-handling capac­ity and wide, smooth frequency response.

The TS992-LX features a single ultrahigh­reliability, ultrahigh-output 381-mm (15-in.)
EVX-150A woofer, with continuous pro­gram power capacity of 1,000 watts. The
EVX-150A is crossed over at 1,150 Hz
where its coverage pattern is a perfect match
to that of the HP99 compact 90° x 90° horn
to which a DH2As1 medium-format “short
nose” compression driver is mounted. The
unique, 90° vertical coverage angle of the
HP99 horn provides more uniform coverage
at the front of small rooms.

All components of the TS992-LX are black
finished to eliminate any light reflections back
through the screen. The high-frequency horn
is matte black and the black textured finish

TM

theatre stage system for

®

-approved

of the low-frequency system is of low
reflectivity. The TS992-LX is mechanically
designed for easy installation, including con­venient system connection and horn aiming
(see Installation section).

The TS992-LX provides high performance for
all film-sound formats in small size rooms.

®

THX

recommends the TS992-LX in rooms
of up to 1,274 m
and stage-to-last-row distances of up to
12 m (40 ft).

Frequency Response

Figure 2 shows TS992-LX frequency re­sponse with presets of the Electro-Voice
Dx34A digital speaker system processor (see
Crossover and Basic Equalization section).
The measurement was made with a swept
sine-wave signal, 4 volts at 500 Hz, in an
anechoic (echoless) environment. The micro­phone was at a distance of 3.0 m (10 ft), on
an axis at the lower edge of the high-fre­quency horn. Figure 3 shows the frequency
response of the individual sections of the
TS992-LX, measured under the same condi­tions but with a 4-volt input constant with
frequency, the results of which were then nor­malized to 1 watt/1 meter.

3

(45,000 ft3) in volume

TS992-LX

Biamped Theatre Stage
System

• Only 254 mm (10 in.) deep
overall-more room for seats

®

• THX

• Digital Dynamics Capable

• Wideband response—30-20,000 Hz

• 90° x 90° coverage pattern

Crossover and Basic System Equalization

In THX
tem equalization is provided by a dedicated
THX crossover/EQ/signal-delay unit. In con­ventional installations, the Electro-Voice
XEQ-2 analog crossover/equalizer/delay
equipped with the appropriate optional cross­over and horn EQ modules or the Electro-V oice
Dx34A digital speaker system processor may
be used. Contact Electro-V oice for information
on specific XEQ-2 modules and Dx34A pre­sets.

Installation

The TS992-LX incorporates a number of in­staller-recommended features, for quick,
trouble-free and low-cost installation. Among
these features is a top-mounted input panel
for the TL15-1XS low-frequency system,
perfect when space is restricted to the rear or
sides of the system. In addition, through the
use of the supplied HMK-4 horn-mounting
kit and T-nuts in the top of the low-frequency
system, the high-frequency section is easily
mounted in the proper position on top of the
low-frequency section. The HMK-4 allows
±30° of horizontal horn aiming and +10°/–15°
of vertical aiming. Complete installation in­structions are on the engineering data sheet
supplied with the HMK-4.

approved for small sized

3

rooms—up to 1,274 m

3

) with stage-to-last-row dis-

ft

(45,000

tances up to 12 m (40 ft)*

TM

—
DH2As1 compression driver and
EVX-150A 15-in. woofer are
highly resistant to long-term
mechanical fatigue

appropriate for smaller rooms

®

installations, crossover and basic sys-

TS992-LX Biamped Theatre Stage System

Limited Warranty

Electro-Voice products are guaranteed
against malfunction due to defects in mate­rials or workmanship for a specified period,
as noted in the individual product-line
statement(s) below, or in the individual prod­uct data sheet or owner’s manual, beginning
with the date of original purchase. If such
malfunction occurs during the specified pe­riod, the product will be repaired or replaced
(at our option) without charge. The product
will be returned to the customer prepaid. Ex-
clusions and Limitations: The Limited
W arranty does not apply to: (a) exterior fin­ish or appearance; (b) certain specific items
described in the individual product-line
statement(s) below, or in the individual prod­uct data sheet or owner’s manual; (c) mal­function resulting from use or operation of

TS992-LX Biamped Theatre Stage System

the product other than as specified in the
product data sheet or owner’s manual; (d)
malfunction resulting from misuse or abuse
of the product; or (e) malfunction occurring
at any time after repairs have been made to
the product by anyone other than EVI Audio
Service or any of its authorized service repre­sentatives. Obtaining Warranty Service:
To obtain warranty service, a customer must
deliver the product, prepaid, to EVI Audio
Service or any of its authorized service rep­resentatives together with proof of purchase
of the product in the form of a bill of sale or
receipted invoice. A list of authorized ser­vice representatives is available from
EVI Audio Service at 600 Cecil Street,
Buchanan, MI 49107 (800/234-6831 or FAX
616/695-4743). Incidental and Conse-
quential Damages Excluded: Product re­pair or replacement and return to the cus­tomer are the only remedies provided to the

customer. Electro-Voice shall not be liable
for any incidental or consequential damages
including, without limitation, injury to per­sons or property or loss of use. Some states
do not allow the exclusion or limitation of
incidental or consequential damages so the
above limitation or exclusion may not apply
to you. Other Rights: This warranty gives
you specific legal rights, and you may also
have other rights which vary from state to
state.

For warranty repair or service informa­tion, contact the service repair department
at: 616/695-6831 or 800/685-2606.

For technical assistance, contact Technical
Support at 800/234-6831 or 616/695-6831,
M-F, 8:00 a.m. to 5:00 p.m. Eastern Stan­dard Time.

Specifications subject to change without
notice.

Figure 1—Dimensions